User manual JBSYSTEMS LIGHT CLUB LASER V 1.1

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this Briteq product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] If you sell the fixture, be sure to add this user manual. Check the contents: Check that the carton contains the following items: CLUB LASER 7 dB25/dB25 ILDA cable Flight case 2 keys (for key switch) Mains cable Operating instructions According to the EN 60825-1:1994 + A1:2002 + A2:2002 regulations, this laser falls under the classification 3B. Laser radiation can cause eye damage and/or skin damage. All protective measures for a safe operation of this laser must be applied. This product is a so-called show laser, emitting radiation with a wavelength spectrum between 400 and 700 nm and producing lighting effects for shows. Due to the construction of this laser, the beam is moved so fast, that it can only hit the eye very short. This is why the use of this laser for a Laser-Light-Show can be regarded as save. Never direct the laser beam to people or animals and never leave this device running unattended. The operation of a class 3B show laser is only allowed if the operation is controlled by a skilled and well-trained operator. Depending on the classification, operating a laser product can produce laser radiation that may cause permanent eye damage and/or skin damage. The legal instructions for using a laser product vary from country to country. The user must always inform himself on the legal instructions valid in his country and apply them to his situation. Please note that BRITEQ cannot be made liable for damages caused by incorrect installations and unskilled operation!SAFETY EYE: used to attach a safety cable when the unit is rigged (see paragraph "overhead rigging") 7. oN/OFF KEY ACTIVATED SWITCH: used to switch the laser beam on/off. Use the keys to make sure only a skilled operator is able to switch the laser on. INTERLOCK input: used to connect the optional emergency stop switch (see picture). When you push this switch the laser beam will disappear immediately. For your own safety we strongly recommend to connect this optional switch!DISPLAY: shows the selected DMX address when the unit is in DMX-mode. Apart from DMX-mode you can also select 4 other working modes, see further to learn more about these modes. DIP-SWITCHES: switches 1~8 are used to set the DMX address between 000 and 255. [. . . ] Begin address = 01 switch 1=ON values: 1 Begin address = 05 switch 1+3=ON values: 1+4 = 5 Begin address = 09 switch 1+4=ON values: 1+8 = 9 Begin address = 13 switch 1+3+4=ON values: 1+4+8 = 13 . Begin address = 62 switch 2+3+4+5+6=ON values: 2+4+8+16+32 = 62 The display helps you to check if the desired starting address is correct. Once the address is set you can switch the unit on with the mains on/off switch (1). 5) ILDA CONTROL: This laser can be controlled by any PC equipped with ILDA compatible software + hardware. [. . . ]