User manual JBSYSTEMS LIGHT COLOR BURST V 1.0

[. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. [. . . ] Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. Optical lenses + lamp compartment Mains cable Fuse holder Cooling fan Button used to control the music sensitivity Microphone Earth connection This symbol means: indoor use only. This symbol determines: the minimum distance from lighted objects. The minimum distance between light-output and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. A new light effect sometimes causes some unwanted smoke and/or smell. This is normal and disappears after some minutes. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Wait for about 10 minutes until the unit has been cooled down. Hold the lamp socket while pressing the new lamps gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Never install lamps with a higher wattage!Lamps with higher wattage generate temperatures the device was not designed for. [. . . ] Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics. Clean with a soft cloth using normal glass cleaning products. Clean the external optics at least once every 30 days. Clean the internal optics at least every 90 days. [. . . ]