User manual JBSYSTEMS LIGHT CYCLOPE V 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. MENU button: used to select the different menu items DOWN button: to go back in the menu and to lower the values shown on the display. uP button: to go up in the menu and to increase the values shown on the display. ENTER button: used to confirm your choice. MAIN MENU: To select any of the menu options, press the MENU button up to when the required one is shown on the display. Use DOWN and UP button to choose the desired menu option. once the required menu option is selected , press the ENTER button to select. To go back to the functions without any change press the MENU button or just wait 8 seconds. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Once the mode is selected, press the ENTER button to setup (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Working Mode Used to set the unit in master or slave mode. press the MENU button until is shown on the display. Press the ENTER button, the current working mode starts blinking in the display Use the DOWN and UP buttons to select (master), (slave in sync with the master) or (2 light show ­ slave in antisync with the master). Once the mode is selected, press the ENTER button save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. [. . . ] channel 1: mode selection (pattern , chase , stand-alone) Channel 2: select patterns or chases. Channel 3: strobe speed (pattern mode) or chase speed (chase mode) Channel 4: general dimmer 10 channel mode: Uses more DMX-channels on your controller but all LED clusters can be controlled individually so you have total control!Channel 1: mode selection (pattern, chase, stand-alone) Channel 2-8: select a different pattern or chase for each of the 7 LED-clusters: o Channel 2: LED cluster 1 o Channel 3: LED cluster 2 o. O Channel 8: LED cluster 7 Channel 9: strobe speed (pattern mode) or chase speed (chase mode) Channel 10: general dimmer Make sure the area below the installation place is free from unwanted persons during servicing. [. . . ]