User manual JBSYSTEMS LIGHT DB-46 V 1.0

[. . . ] To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Don't place metal objects or spill liquid inside the unit. [. . . ] overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. SLIDING MECHANISM: used to distribute your projectors evenly over the DB-46. END CAP: To install the bolts/nuts (needed to fix the projectors) and stand adapter you have to remove this end cap on one side of the unit: simply unscrew the 4 screws remove the cap put the nuts/bolts and/or stand adapter in the sliding rail put the cap back in place fix the 4 screws done!CHANNEL OUTPUTS: Each channel output has its own output socket to connect any resistive and/or inductive projector(s) or small light effects. The detector lights up when the channel fuse is blown. Always replace the blown fuse with a fuse that has the same characteristics!IMPORTANT NOTE: It's very important to know that the maximum load for each channel is rated at 8A or 1850Watts. However the total load for all 4 channels may not exceed 20A or 4600Watts!POWER INPUT: mains input, equipped with a Neutrik Powercon , make sure the local voltage is 230Vac and the projectors (and/or light effects) are properly connected to the channel output sockets (1) before you connect an earthed mains cable to this input. When the fuse is blown, first locate and solve the problem that caused the fuse to blow. [. . . ] You can even give 2 or more channels the same DMX address. press the ENTER button to browse through the menu. Once you selected the desired channel, press the UP/DOWN buttons to set the address Press the MENU button to return to the main menu. MODE MENU: This menu is used to set the working mode of the 4 output channels. [. . . ]