User manual JBSYSTEMS LIGHT DFX48 V1.0

[. . . ] `t Hofveld 2 ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. This symbol means: indoor use only Thank you for buying this SYNQ product. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] If you sell the fixture, be sure to add this user manual. To protect the environment, please try to recycle the packing material as much as possible. Check the contents: Check that the carton contains the following items: User manual DFX-48 effect processor CDROM with PC-software Mains cable CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. Connections can be made with balanced/unbalanced jack or XLR-cables. Please only use good quality cables to minimize noise and interference. The DFX-48 can be connected in two ways: - Between a line level audio source and the input of your mixer. - To the channel effect sends or AUX of a PA-mixer (effect send switched in post fader mode) VIA PA-MIXER EFFECT SEND / AUX (set the direct signal level to 0%) BETWEEN AUDIO SOURCE AND MIXER INPUT (set the direct signal level to your own taste) A Shows program number + name B Shows the different effect parameters C Flashes when you can save the new settings A Shows one of the 5 frequencies of the equalizer B Shows the gain of the equalizer (+/-12dB) C Flashes when you can save the new settings SIGNAL METER: indicates the level of the input signal, please check n°14 to see how you can adapt the input sensitivity. EDIT WHEEL: used to browse the different effect programs. To select an effect you must confirm your choice by pressing the ENTER button (9) within 5seconds. The edit wheel is also used to adjust the different effect parameters. PROGRAM BUTTON: used to select the different effects. Press this button to shift between the user editable programs (display shows U01 to U48) and factory preset effects (display shows P01 to P48). LOCK BUTTON: press this button for some seconds to lock all buttons (on the right of display line1 a "key symbol" appears). Press this button again for some seconds to unlock all buttons ("key symbol" disappears) 6. BYPASS BUTTON: press this button for some seconds to bypass the effect signal, only the original (direct) signal will pass. PARAMETER BUTTON: each effect uses different parameters, with the parameter button you can browse these parameters. When a parameter is followed by a flashing ":", it can be changed with the EDIT WHEEL (3). When "SV" appears on the display, you can use the ENTER button (9) to save the new settings see point 9 for more information. EQ/RESET BUTTON: This button has two functions: EFFECT EQ: the sound of each effect can be modified using a 5band equalizer. The equalizer has 5 fixed frequencies (62Hz, 250Hz, 1kHz, 2kHz, 8kHz) that all can be adjusted from -12dB to +12dB in 1dB-steps. [. . . ] INSTALLING THE SOFTWARE: ® Very important: before you install the Windows software you should install a driver to ensure the USB communication! part1 ­ installing the USB driver AUTOMATIC installation: First connect the DFX-48 with your PC via USB and switch the DFX-48 on. Windows will detect new hardware and ask you if it can search and install a driver via internet: accept this option. windows will try to install the driver automatically. [. . . ]