User manual JBSYSTEMS LIGHT FL-1800

[. . . ] Main Office/Factory: Geni Electronics Co. , Ltd. 22, Chung Cheng 5th Street Yung Kang Tainan Hsien, Taiwan Tel: 886-6-253-8513 Fax: 886-6-253-8685 Showroom: Geni Electronics Co. , Ltd. Taipei World Trade Center, Room 3A-04 No. 5, Section 5, Hsin Yi Road, Taipei, Taiwan Tel: 886-2-2722-2910 Fax: 886-2-2722-2918 Thank you! Appendix FL-1800 Golden Strobe Up Panel C B A Get the best -- get Geni! Geni Quality Sets the Standard 4 Description A high-powered, 2000W strobe light with manual and remote control, Golden Strobe FL-1800 features controllable flash speed, quiet operation, lasting value. Inspection Every Golden Strobe (FL-1800) is thoroughly tested at the factory and shipped in perfect condition. [. . . ] Product contains no user serviceable parts. Refer servicing to qualified technicians only. Plug strobe power cord into appropriate mains power supply. Turn the flash speed dial (See Appendix. A) on upside of unit back to adjust the flash speed. (There is a small, white adjustment knob on the unit. This SVR can be adjusted with a screwdriver. Note, however, that this SVR is adjusted to the optimal position at the factory. ! Remote Control Operation For best results, use Geni FL-01C or FL-34C controllers. Abide by controller user manual specifications regarding the number of strobes that can be linked to one controller. Plug one end of a mono (not stereo) microphone signal cable with standard 1/4-inch mono microphone jacks (See Appendix. B) into the Signal Input connector on upside of unit. Plug the other end of the cable into the signal output socket on the controller. If desired, connect another strobe: Plug one end of another signal cable into the Signal Output socket (See Appendix. C) on the upside of the first strobe; Plug the other end of the signal cable to the Signal Input socket on the upside of the second strobe. Follow the same procedure to link more strobes, if desired. Set all strobe manual control knobs to the Off (no flash) position. Refer to your strobe controller user manual for operating instructions. Plug strobe and controller mains power cords into proper electric power supply. ! 1 Troubleshooting Golden Strobe (FL-1800) are designed for years of troublefree use. [. . . ] If strobe flashes in manual control but not under remote control, replace the remote control cable. Use a cable that has worked properly with other strobes. If strobe still doesn't flash under remote control, check to see if other strobes operate properly with this controller. Refer servicing of strobe and controller to a qualified technician. [. . . ]