User manual JBSYSTEMS LIGHT FX 1000 V 1.1

[. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. [. . . ] When the problem is solved, replace a damaged fuse with a fuse of the same type and electrical specifications. MAINS CABLE: to be plugged in a mains wall socket with earth connection. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol determines: the minimum distance from objects. The minimum distance between fogger output and objects must be more than 1 meter. NEVER hold your hands close to the fogger output, the fog is very hot and can cause serious burnings !To protect the environment, please try to recycle the packing material as much as possible. Put the fogger on a flat and very stable surface. Make sure that nobody can put their hands just in front of the output. The fog is very hot and can cause serious burnings!Make sure the fog liquid tank is not empty. Always use good quality fog liquid to fill up the tank. Close the tank immediately to prevent dirt to enter the reservoir! plug the supplied remote in the "remote control" input (2) on the back of the unit. Don't insert or remove the remote while the fogger is connected to the mains!Make sure to plug the fogger in a mains wall socket with earth connection Switch the fogger on and wait for about 8 minutes. (warm up time) IMPORTANT: Please note that the fogger is ready when the green LED on top of the "manual fogging" button (n°3 on the remote) is on. used with the supplied timer/dmx remote controller: 1. REMOTE CABLE: connect the special 5pin connector (1) to the remote input on the back of the fogger. DMX OUTPUT: 3-pin female connector, used to connect the fogger with the next unit in the DMX chain. [. . . ] The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. Cleaning the fogger: To prevent obstructions in the heater, pump and tubes, the fogger should be cleaned on a regular basis: every 100h of continuous operation is a good reference. Switch the fogger off Remove the nozzle (metal part where the fog leaves the fogger) Remove the fog liquid from the tank Fill the tank with about 1liter of a solution containing 80% distilled water and 20% white vinegar. Switch the fogger on and wait for about 8minutes (warm up time) Put the fogger in continuous operation mode until the tank is empty Put the nozzle back in place Remove the eventual residues of the cleaning solution and refill the tank with fog liquid. [. . . ]