User manual JBSYSTEMS LIGHT IMOVE 7S V1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] Be sure that the wires don't touch the lamp. Close the lamp compartment with the screws Turn on the unit and point the beam to a white surface. Use the three adjustment screws indicated by "lamp adjust". Gently turn these three screws until you obtain maximum light output. ATTENTION: Install the gobos only when the unit is switched off! never unscrew the screws of the rotating gobo as the ball bearing will be opened. switch off the main supply and unplug the unit. Open the plastic top cover (4screws) Locate the gobo wheel and remove the fixation ring of the gobo you want to change with an appropriate tool. remove the gobo and insert the new gobo. Press the fixation-ring together and insert it in the front of the gobo. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The fixture must be fixed at least 50cm from surrounding walls. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered! [. . . ] Read more about this option in the "Main Menu" paragraph. mASTER has 4 built-in shows: You can select (show 1) , (show 2) , (show 3) or (show 4) directly in the menu of the master. SLAVES have 2 working options: The other units are set to slave mode (slaveLED is constantly on). In order to create a great light show you can introduce contrast movements (pan/tilt of slave is inversed) In the menu of the slave units you can go to option and select: o Normal slave: slave works in sync with the master. [. . . ]