User manual JBSYSTEMS LIGHT LED DEVIL V 1.1

[. . . ] An extremely compact, DMX-controlled, LED effect This powerful, eye-catching, LED effect uses 3 optical discs and 6 lenses to obtain an incredible, brilliant and innovative light effect!0-100% dimming and ultra fast strobe function Different user modes for maximum flexibility: DMX-control: 3 channels for full control of dimmer/strobe, colors, rotation speed/direction Standalone: automatic or sound activated with internal mic Master/slave: wonderful synchronized shows Optional CA-8 remote controller available Based on a powerful 10Watt RGB LED: Extremely brilliant beams compared to effects with halogen lamps More dynamic effects compared to effects based on halogen lamps No lamp replacements!Very low power consumption Lightweight (no lamp transformers needed) This symbol means: indoor use only This symbol means: Read instructions To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. [. . . ] Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. Check the contents: Check that the carton contains the following items: Operating instructions Led Devil Mains Cable Hanging bracket + 2 bolts & 2 nuts The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Electrical installation in DMX-mode: The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable. Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these cables are compatible with balanced audio cables. pin layout XLR-3pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) Pin layout XLR-5pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) ~ Pins4+5 not used. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. Never use Y-splitter cables, this simply won't work!Make sure that all units are connected to the mains. Each light effect in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. In the next section you will learn how to set the DMX addresses. This input receives instructions from a DMX-controller or from another Led Devil in master/slave mode. DMX output: 3pin female XLR-connector used to connect the Led Devil with the next unit in the DMX chain or with another Led Devil when used in master/slave mode. [. . . ] The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics. Clean with a soft cloth using normal glass cleaning products. Clean the external optics at least once every 30 days. [. . . ]