User manual JBSYSTEMS LIGHT LED FLOWER DMX V2.00

[. . . ] CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This product meets the requirements of the current European and national guidelines. [. . . ] Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. Electrical installation for two or more units in master/slave: Connect 2 to maximum 16 units together using good quality balanced microphone cables (like for example JB Systems ref. The unit that has no cable connected to its DMX-input will react as "master", the others are the slave units. Make sure that all units are connected to the mains. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation. You can also connect the LEDCON 01 remote controller, in this case all units will respond equally (all units have the same color) An example to make things clear: We want to set the DMX-addresses of 16 units, the DMX start address of the first projector must be 202: Connect all projectors to the DMX-controller as described above and make sure all are switched on. Set all DMX-channels on the controller to zero (000) Now set DMX-channel 202 to maximum (255) Press the "Auto DMX address" button (6) on the first projector in the chain for about 5seconds. The first projector in the chain will receive DMX-start address 202 and it will automatically calculate and program the DMX addresses of all the other units in the DMX-chain!Nd rd This means that the 2 projector automatically receives address 206, the 3 has address 210, th . , until the 16 projector who automatically receives start address 262. You just programmed 16 projectors, this took you about 10seconds!Remark: you can mix the units with other DMX-effects that don't have the automatic DMXaddressing option. [. . . ] Now you can control all the connected units: IMPORTANT REMARK: When you use this LED PROJECTOR with a CA-8 controller and you select MANUAL mode (mode LED = ON), the projector reminds the last setting used with controller, even after disconnecting the controller and/or the mains voltage. If you don't want this, make sure to select another working mode (mode LED must blink or off) before you unplug the controller. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. [. . . ]