User manual JBSYSTEMS LIGHT LED PANEL V 1.5

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. [. . . ] Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. Important: The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. electrical installation for 1 standalone unit: Just insert the mains cable. The unit starts working immediately in stand-alone mode Remark: You can connect a CA-8 remote controller to the unit if you want to have more control. refer to section "C" of the operating instructions to learn how to do this. Electrical installation for two or more units in master/slave: Connect 2 to maximum 16 units together using good quality balanced microphone cables (like for example JB Systems ref. The unit that has no cable connected to its DMX-input will react as "master", the others are the slave units. Make sure that all units are connected to the mains. Remark: You can connect a CA-8 remote controller to the master unit if you want to have more control over the master/slave operation. You can also connect the LEDCON 01 remote controller, in this case all units will respond equally (all units have the same color) Electrical installation for two or more units in DMX-mode: 230V Mains input with male IEC cable connector 230V Mains output with female IEC cable connector DMX input with male XLR cable connector DMX input with female XLR cable connector CA-8 controller input Internal microphone "Auto DMX-address" button 4 fixing holes Plastic screws used to fix the front cover on the base The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable (ex. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. Never use Y-splitter cables, this simply won't work!Make sure that all units are connected to the mains. Each LED panel in the chain needs to have its proper starting address so it knows which commands from the controller it has to decode. In the next section you will learn how to set the DMX addresses. How to set the DMX addresses: There are 2 ways to set the DMX-address of the units. If you use setting options A or B you MUST set ALL DIP-switches to OFF position!Setting individual DMX-addresses per projector: Make sure the DMX cables of all units are connected. [. . . ] This is how you fix the panels: Check the picture with dimensions on the right. Based on these dimensions you can easily locate where you have to drill the holes on the mounting surface. Fix for each panel 4 screws on the mounting surface at an appropriate distance. These screws should have a diameter of about 3 to 4mm with a head diameter of 7mm. [. . . ]