User manual JBSYSTEMS LIGHT LED PIPE CONTROLLER V 1.2

[. . . ] The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard Never let the power-cord come into contact with other cables!In order to avoid a hazard, the unit shall only be used with the AC-adaptor delivered with it. If the ACadaptor is damaged, a same model adaptor shall be used only. [. . . ] UP BUTTON: used to choose a higher value for the selected parameter or to navigate in the menu structure. see chapter "How to use" for more information 5. DOWN BUTTON: used to choose a lower value for the selected parameter or to navigate in the menu structure. The last working mode is saved when the controller is switched off. DMX INPUT: The RGB LED PIPE controller only receives DMX signals so it must be connected as any other light effect in the DMX line. DMX OUTPUT: The 3pin female XLR-connector is used to connect the controller with the next unit in the DMX chain. SIGNAL OUTPUT: connect this cable to the first led tube in the chain. Extra signal cable extensions are optionally available in different lengths. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Don't place metal objects or spill liquid inside the unit. No objects filled with liquids, such as vases, shall be placed on this appliance. electric shock or malfunction may result. If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. Prevent use in dusty environments and clean the unit regularly. [. . . ] There are 4 modes, each with 8 different patterns: o Auto mode: 8 automatic patterns (speed to be selected, not music controlled) o When a pattern is selected you still have to select the desired speed (speed is blinking). O For some patterns you also have to choose in which direction the pattern should run (current direction is flashing) choose "left" or "right" and confirm with ENTER. O Sound mode: 8 music activated patterns o For some patterns you have to choose in which direction the pattern should run (current direction is flashing) choose "left" or "right" and confirm with ENTER. O dB mode: 8 music activated "VU meter-like" patterns o When a pattern is selected you still have to select the desired speed (speed is blinking). [. . . ]