User manual JBSYSTEMS LIGHT LED PIPE RGB 230V V 1.0

[. . . ] Condense sometimes prevents the unit from working at full performance or may even cause damages. Don't place metal objects or spill liquid inside the unit. electric shock or malfunction may result. If a foreign object enters the unit, immediately disconnect the mains power. [. . . ] Internal power supply for easy daisy chaining of up to 200 units on only one 230V/16A wall socket!Can be easily fixed to walls and ceilings with the supplied wall brackets. 000 hours Low power consumption: only 18W per tube!Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. Check the contents: Check that the carton contains the following items: Operating instructions LED PIPE RGB unit CAUTION: To reduce the risk of electric shock, do not remove the top cover. LED PIPE SIGNAL INPUT: low voltage signal input to be connected with the signal output of the previous tube or with the signal output cable from the controller. LED PIPE SIGNAL OUTPUT: low voltage signal output to be connected with the signal input of the next tube. POWER INPUT CABLE: To be connected with power output cable of the previous tube or directly with the mains. POWER OUTPUT CABLE: To be connected with the power input cable of the next tube. LED PIPE HOLDERS: Needed to fix the tubes easily against a surface. The shape of the enclosure and the holders makes it possible to hide your cables perfectly behind your construction. DIP SWITCHES: used to setup the different user modes of the tube. PLASTIC COVER: The milky white plastic cover is used to mix the 3 primary colors. If you like you can install the LED PIPE tubes behind a big milky white opaque surface to create an "ever color changing wall". In this case you can try to remove the plastic cover from the LED PIPE to obtain more light output. [. . . ] Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. The cleaning of external optical lenses and/or mirrors must be carried out periodically to optimize light output. [. . . ]