User manual JBSYSTEMS LIGHT LED RAVE V 1.0

[. . . ] ) Extremely brilliant colors compared to units with halogen lamps No lamp replacements!Virtually no heat production Lightweight (no lamp transformers needed) Big light output and 15 sharp gobos, thanks to excellent optics 2 switches control gobo and reflector dish for continuous or sound activated rotation Sound activated movements by built-in microphone Ultra fast strobe function Thanks to 1channel DMX control, the unit can be switched on/off by any DMX-controller. Perfect for small applications: discos, clubs, mobile DJs, home, . Before you start using this unit, please check if there's no transportation damage. [. . . ] never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. To protect the environment, please try to recycle the packing material as much as possible. A new light effect sometimes causes some unwanted smoke and/or smell. This is normal and disappears after some minutes. Hanging bracket with 1 knob to fasten the unit and a mounting hole to fix a mounting hook. Heatsink for the LED: do not cover this part to ensure proper cooling. Mains output with IEC socket: you can use a special IEC power cable to connect this output with the mains input of the next LED RAVE for easier linking. This input receives instructions from a DMX-controller. DMX output: 3pin female XLR-connector used to connect the LED RAVE with the next unit in the DMX chain. Gobo wheel switch: Position 0: gobo wheel stops rotating Position I: gobo wheel rotates at a constant speed Position II: gobo wheel rotates to the rhythm of the music 11. Reflector dish switch: Position 0: reflector dish stops rotating Position I: reflector dish rotates at a constant speed Position II: reflector dish rotates to the rhythm of the music How to set the DIP-switches to obtain the right starting address: Each of the first 9 DIP-switches correspond to a certain DMX-value: DIP #1 #2 #3 #4 #5 #6 #7 #8 Value 1 2 4 8 16 32 64 128 Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. [. . . ] You need to "daisy chain" your DMX controller and all the connected units with a good quality balanced cable. Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these cables are compatible with balanced audio cables. pin layout XLR-3pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) Pin layout XLR-5pin: Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal (+) ~ Pins4+5 not used. To prevent strange behavior of the light effects, due to interferences, you must use a 90 to 120 terminator at the end of the chain. [. . . ]