User manual JBSYSTEMS LIGHT LEDCON-02 V 1.1

[. . . ] CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. [. . . ] Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. To protect the environment, please try to recycle the packing material as much as possible. Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. POWER SWITCH: used to switch the unit ON/OFF 10. dC INPUT: connect the supplied AC/DC adapter to this input. If you should use another adapter, please make sure that it has 9Vdc and minimum 300mA with + in the center. CHASER CHANNEL MODE: used to determine if the LEDCON-02 should work as a 4 or 8 channel LED light modulator. Please note that you should always run the "auto address" function after changing the channel mode!COLOR / CHASE BUTTONS: These buttons have different functions, depending on the selected working mode (refer to n°2): FIXED COLOR MODE: You can select 9 different predefined colors. CHASE 2: You can select 8 different chases and a random chase. (sound activated or not) AUTO ADDRESS MODE: You can determine the order of succession of the connected LED PARprojectors. MODE SELECT BUTTONS: 3 buttons used to set the controller in different working modes: FIXED COLORS: select this mode if you want to use the "fixed color" buttons (1). CHASE MODE: used to select two different chase modes: CHASE 1: select this mode if you want to select one of the 12 color chases using the "chase/color" fader (3). CHASE 2: select this mode if you want to use the controller as a 4 or 8 channel DJ light modulator. You can use the "color / chase buttons" (see n°1) to select the different chases. SPECTRUM MIX: select this mode if you want to select one of the 32 different colors using the "chase/color" fader (3). CHASE/COLOR FADER: used to select one of the available color chases: Left side of the fader indicates the different chases. right side of the fader indicates the different colors. [. . . ] First determine if you will put the LEDCON-02 in 4 or 8 channel mode (see switch n°12) B. Press the "blackout" button (see n°8) for about 5seconds: until the red "blackout LED" starts blinking. You will see notice that the first LED projector in the chain is lit. Press the "blackout" button again for about 5 seconds, until the "blackout" LED stops blinking. [. . . ]