User manual JBSYSTEMS LIGHT LOGO PROJECTOR V 2.1

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Lamp compartment, to be opened with this knob 5. Fixation ring, used to keep the gobo in place. This symbol determines: the minimum distance from lighted objects. The minimum distance between light-output and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. A new light effect sometimes causes some unwanted smoke and/or smell. This is normal and disappears after some minutes. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Wait for about 10 minutes until the unit has been cooled down. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Never install lamps with a higher wattage!Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. [. . . ] O DIP9: Rotation direction (left or right) o DIP10: Rotation on/off switch Regular breaks during operation are essential to maximize the life of this device as it is not designed for continual use. Do not switch the unit on and off in short time intervals as this reduces the lamp life. the units' surface temperature may reach up to 85°C. Don't touch the housing with bare-hands during its operation. [. . . ]