User manual JBSYSTEMS LIGHT MICROL LED MANAGER V 1.0

[. . . ] `t Hofveld 2 ~ B1702 Groot-Bijgaarden ~ Belgium Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. In the chapter DMX-addressing, we explain how DMX-addressing can be done. DIP10 = ON Master operation (stand-alone) Use the dipswitches 1~9 to set the mode, speed, patterns, fixed color color. Below each of these functions is explained in detail. INTERNAL MICRO: used for sound activated chases. This input receives instructions from a DMX-controller or from another Micro / Mini LED Manager when used in master/slave mode. DMX OUTPUT: 3pin female XLR-connector used to connect the Micro Led Manager with the next DMX appliance in the chain or with another Micro / Mini LED Manager when used in master/slave mode. The Micro / Mini LED Manager can also be used as controller for other LED projectors like for example "LED PAR56/64" 4. DIP SWITCHES: when used in DMX mode (DIP10 = OFF) you can set the DMX-starting address of the unit. When used in stand-alone mode (master, DIP10 = ON), you can use the DIP-switches to set different pre-programmed options. AUTO DMX ADDRESS BUTTON: see further to learn how to set the DMX address easily. OUTPUT TERMINALS: used to connect different 24Vdc common anode LED projectors. You can connect any 4pole electrical wire to connect the LED-projectors to this output. However to make life easier for you we suggest using the special CCM-50 cable (role = 50m). ANALOG SWITCH INPUT: used to connect any external analog switch. This external switch can be used to switch the general output of the Micro / Mini LED Manager on/off. (external blackout) See further for more information on how to connect the analog switch. WALL DIMMER INPUT: used to connect our LED WALL DIMMER, a small LED controller that fits in any standard "electrical wall box". See further for more information on how to connect the LED WALL DIMMER. STATUS LED: shows the status of the unit, should blink when DMX is detected. Connecting the optional LED WALL DIMMER: The LED WALL DIMMER is a small, easy to use, controller that can be installed in any standard wall connection box. [. . . ] Set the DMX-channel, that you want to assign as DMX-start address on your Micro / Mini LED Manager to maximum (value 255) Press the "Auto DMX address" button (6) on the Micro / Mini LED Manager shortly. If you want to set another unit to the same DMX-start address, simply press it's "Auto DMX address" button (6) and it will receive the same address. An example to make things clear: We will set the DMX start address of a Micro / Mini LED Manager to 106: Connect the Micro / Mini LED Manager to the DMX-controller as described above and make sure all is switched on. Your Micro / Mini LED Manager now has DMX address 106! [. . . ]