User manual JBSYSTEMS LIGHT MLS-50 V 1.0

[. . . ] Two-side adhesive tape for easy fixing included Can be fixed on any surface using small screws Elegant "slim line" design!Strips can be fixed without gaps between the units: no interruptions in the light output!No visible connection cables, they are completely hidden inside the units Available in 2 lengths: 20cm and 50cm To be used with our LED-MANAGER (DMX power supply) Long life LED Technology! Inexperienced persons should not operate this device. [. . . ] Input connector (mounted on the bottom side): to be linked with the LED manager or with the output of a previous LED strip in the chain. Output connector (mounted on the bottom side): to be linked with the input of a next LED strip in the chain. To protect the environment, please try to recycle the packing material as much as possible. Do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Don't place metal objects or spill liquid inside the unit. If a foreign object enters the unit, immediately disconnect the installation setup from the mains power. Prevent use in dusty environments and clean the unit regularly. Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during installation and servicing. Before installation make sure that the installation area can hold a minimum point load of 10times the device's weight. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Mounting with Two-side adhesive tape: This is the easiest and fastest way but only possible on a smooth surface!Put it on the bottom or side of the U-shaped enclosure as shown on the drawings. Mounting with smallscrews: This takes a little more time but the mounting surface doesn't have to be so smooth, you can even fix the LED strip on a surface covered with carpet. remove the PCB from the U-shaped plastic rail just by sliding it to one side. [. . . ] The cleaning of the plastic enclosure must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics. Clean with a soft cloth using normal glass cleaning products. After installing the units just daisy chain the in/output cables of all LED STRIP units up to the maximum allowed load. [. . . ]