User manual JBSYSTEMS LIGHT MM-10 MIXER V1.1

[. . . ] The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. To protect the environment, please try to recycle the packing material as much as possible. [. . . ] Attach the unit using the 4 screw holes on the front panel. Be sure to use screws of the appropriate size. (screws not provided) Take care to minimize shocks and vibrations during transport. When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE APPLIANCE: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. In this manual we talk about "line inputs". This is a global name for inputs with a level between 750mV and 2V. PFL SWITCH This switch and indicator allows pre-fade listen of input signals through the headphone and Led meters (useful while setting gains or trouble shooting). LINE INPUT LEFT OR MONO ­ 1/4" Mono Jack Socket If the input is connected to a mono source use this connection only as the signal will automatically be routed to the right input also. 5mV (-30dBm) PAD SWITCH Operation of this switch reduces the input sensitivity by 10Db allowing it to be used with high output devices such as CD players as well as musical instruments. GAIN CONTROL The panel marking at 0dB is a true reference to 0dBm when the ­10dB Pad is engaged. Range: +10dB CLIP LED This warning light will illuminate 4dB before clipping and will remain on for a short period. For optimal input channel running level, adjust Gain Control until Clip indicator illuminates while signal peaks are present. Then adjust the gain setting until Clip indicator is off. [. . . ] Some microphones that do NOT require phantom supply may not operate or are damaged ­ check instructions. The Jack Line inputs will be unaffected and can be used as normal. (Your service station may be able to disable the Phantom Power) 12. STEREO RECORD OUTPUT ­ Left and Right RCA Socket Outputs (unbalanced) The signal is derived from the main stereo output mix after the output faders. [. . . ]