User manual JBSYSTEMS LIGHT MX 3 V1.0

[. . . ] The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. To protect the environment, please try to recycle the packing material as much as possible. [. . . ] (screws not provided) Take care to minimize shocks and vibrations during transport. When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE MIXER: Clean by wiping with a polished cloth slightly dipped with water. Do not use volatile liquids such as benzene or thinner which will damage the unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. this symbol means: Safety Class II appliance This symbol means: Read instructions. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Except for microphone and headphone outputs, all connections are cinch. use good quality cinch-cinch cables to prevent bad audio quality. For more information on connections, please refer to the next chapter. Be sure to turn off the mixer before you make changes to the different connections. In this manual we talk about "line inputs". This is a global name for inputs with a level up to 2V. this includes tuners , videos , CD-players , etc. Both USB connections will be detected as a sound card on your computer. These connections are bidirectional (play/record music simultaneously) This input is mainly used as DJ-microphone. [. . . ] Remove the 2 screws that keep the cross fader in place. Gently remove the fader and the cover plate from their position. Unplug the cross fader from the cable (unplug the cable by pulling the connector, NOT the cable! ) Press the new cross fader on the cable. [. . . ]