User manual JBSYSTEMS LIGHT PCM.1 V1.0

[. . . ] "1-click" beat matching, automatic loops, 4 cue points per track, mix recorder, . 8 samplers (recording/saving samples , volume , beat sync , pitching , effect , PFL , looping , . ) 2 Relooper editors each with effects and 3 fully editable patterns to slice, re-trigger, mute your tracks in perfect beat sync!Any VST-compliant effect can be used to ensure unlimited creativity! [. . . ] Please use the original packing when the device is to be transported. Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual. To protect the environment, please try to recycle the packing material as much as possible. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. INSTALLATION GUIDELINES: Install the unit in a well-ventilated location where it will not be exposed to high temperatures or humidity. Placing and using the unit for long periods near heat-generating sources such as amplifiers, spotlights, etc. Will affect its performance and may even damage the unit. the unit can be mounted in 19-inch racks. Attach the unit using the 4 screw holes on the front panel. Be sure to use screws of the appropriate size. (screws not provided) Take care to minimize shocks and vibrations during transport. When installed in a booth or flight case, please make sure to have good ventilation to improve heat evacuation of the unit. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. CLEANING THE APPLIANCE: Clean by wiping with a polished cloth slightly dipped with water. [. . . ] JOG dial: several functions are available: During normal play: used for pitch bending With JOG SEEK on: used to look up a certain position in the track (see n°18) In pause mode: used to look up a certain position in the track With SCRATCH on: used to simulate vinyl scratching (see n°16) SCRATCH button: used to switch the scratch function on/off PFL button: used to monitor the track via your headphones. jOG SEEK button: enables the "fast search" function to look up a certain part of a track. PITCH fader: used to change the speed of the loaded track. PITCH BEND+/- buttons: used to match the beats of two tracks, can be used in two ways: Press PITCH BEND+/- buttons: the music will play faster/slower as long as you press the buttons. [. . . ]