User manual JBSYSTEMS LIGHT POSEIDON V 1.1

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. CAUTION: To reduce the risk of electric shock, do not remove the top cover. The lightning flash with arrowhead symbol within the equilateral triangle is intended to alert the use or the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operation and maintenance (servicing) instructions in the literature accompanying this appliance. This symbol determines: the minimum distance from lighted objects. The minimum distance between light-output and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. A new light effect sometimes causes some unwanted smoke and/or smell. This is normal and disappears after some minutes. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. DIP switches, used to set the DMX-starting address of the unit. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Switch off the unit and unplug the mains cable. Wait for about 15 minutes until the unit has been cooled down. Push the white porcelain part of lamp socket contacts on both sides of the lamp outwards (see "B" on the picture). The contact of the lamp socket will move outwards when you put the lamp in place. Now press the white porcelain part of the other contact gently outwards so the distance between both contacts is big enough to slip the S-shaped lamp in between (see "D" on the picture). Release the pressure on the lamp so it gently clicks in place. [. . . ] overhead rigging requires extensive experience!Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. [. . . ]