User manual JBSYSTEMS LIGHT PUBLI SPOT V 1.0

[. . . ] Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the device and consult your dealer first. Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. [. . . ] Don't connect the unit to any dimmer pack. Always use an appropriate and certified safety cable when installing the unit. In order to prevent electric shock, do not open the cover. Apart from the lamp and mains fuse there are no user serviceable parts inside. never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the fixture and contact your dealer immediately. The housing and the lenses must be replaced if they are visibly damaged. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Important: Never look directly into the light source!Zoom Lens: move this lens on the support bars to increase / reduce the size of the projection. Focus Lens: move this lens on the support bars to adjust the sharpness of the projection. This symbol means: indoor use only This symbol means: Read instructions This symbol means: Safety Class I appliance This symbol determines: the minimum distance from lighted objects. The minimum distance between light-output and the illuminated surface must be more than 1 meters Remove steel ring from the front side and take out the gobo. Place the new gobo and fasten with the steel ring. Once connected to the mains, switch it on with the switch located on the mains cable: the device starts running. Do not switch the unit on and off in short time intervals as this reduces the lamp life. the units' surface temperature may reach up to 90°C. Don't touch the housing with bare-hands during its operation. Always unplug the unit when it is not used for a longer time or before replacing the bulb or start servicing. In the event of serious operating problems, stop using the fixture and contact your dealer immediately. [. . . ] The fixture must be fixed at least 50cm from surrounding walls. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before installation make sure that the installation area can hold a minimum load of 10times the device's weight. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered! [. . . ]