User manual JBSYSTEMS LIGHT PUMA V 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems® product. To take full advantage of all possibilities and for your own safety, please read these operating instructions very carefully before you start using this unit. [. . . ] Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. Important: Never look directly into the light source!Don't use the effect in the presence of persons suffering from epilepsy. This symbol determines: the minimum distance from lighted objects. The minimum distance between light-output and the illuminated surface must be more than 1 meters. To protect the environment, please try to recycle the packing material as much as possible. A new light effect sometimes causes some unwanted smoke and/or smell. This is normal and disappears after some minutes. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. Always unplug the unit before servicing!Always use the same type of spare parts (bulbs, fuses, etc. ) When replacing parts, please only genuine spare parts. Switch off the unit and unplug the mains cable. Wait for about 10 minutes until the unit has been cooled down. Use a screwdriver to unscrew the 2 screws that close the lamp compartment of the fixture. ( A on the picture ) On the inside you will see the lamp socket. tear the lamp socket gently out of the lamp compartment. ( A on the picture ) Unplug the old lamp. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. [. . . ] The installations should be inspected every year by a skilled person to be sure that safety is still optimal. The PUMA can be linked together as master/slave with 2 or 4 units and run the built in program chase sequences by sound activation. When sound stops, all the lights will shut down (blackout) immediately and the bulbs will turn off 15 seconds later. please refer to the unit dipswitch-setting table for the dipswitchsettings to achieve master/slave linking. [. . . ]