User manual JBSYSTEMS LIGHT SM 1612 V 1.2

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. Thank you for buying this JB Systems product. To take full advantage of all possibilities, please read these operating instructions very carefully. [. . . ] Select the fixtures and use the faders and/or joystick to make the desired adjustments to the scene. Once you have completed the changes, press the MIDI/Rec button. Press the scene button that corresponds to the scene you're editing. Note: Be sure to select the same scene in steps d and g, otherwise you may accidentally record over an existing scene. Enter program mode (Press and hold the "Program" button until its LED blinks) b. If you want to check the output, verify that the blackout LED is not lit, if it is, press it once to exit blackout mode. Press the scene button of the scene you wish to copy. Press the Bank Up/Down buttons to select the bank you wish to copy the scene to. Press the scene button you wish to copy the scene to. If you want to copy other scenes, you can repeat steps c to g. Enter program mode (Press and hold the "Program" button until its LED blinks) b. If you want to check the output, verify that the blackout LED is not lit, if it is, press it once to exit blackout mode. While holding the button, press the scene button that corresponds with the scene you wish to delete. When the programmed scene is deleted, all DMX channel values will be set to 0. If you want to delete other scenes, you can repeat steps c & d. The SCANMASTER 1612 only receives MIDI notes and you may have to transpose your keyboard to find the proper notes Enter program mode (Press and hold the "Program" button until its LED blinks) b. Check the blackout button and verify that the LED is not lit, if it is, press it once to exit blackout mode. Verify that the speed and fade time sliders are positioned at zero. You may control several fixtures together by pressing the button corresponding to the fixture(s) you wish to program. (In some rare cases, if necessary, you may select page B to control channels 9-16. Press the bank Up/Down button to choose the bank you want to store this scene into. There are a total of 30 banks you can select, you may store up to 8 scenes in each bank. [. . . ] To do this just select the fixtures you want to lift out of the running sequence and press the override button. Now you can manipulate all functions of the selected fixtures, completely independent from the running sequence. At any moment you can select or unselect additional fixtures. There are three modes in which you can playback chases: 1. [. . . ]