User manual JBSYSTEMS LIGHT SMP 8.2 V1.0

[. . . ] Always drain tank before mailing or transporting this unit. If fog liquid comes in contact with skin or eyes, rinse thoroughly with water. Note: Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact. The shipping carton should contain the following items: 1. [. . . ] Always unplug your ANTARI Z-Series II Fog Machine before filling its tank. always keep fog machine in upright position. Turn off or unplug the machine when not in use. If moisture, water, or fog fluid gets inside the housing, immediately unplug the unit and contact a service technician or your ANTARI dealer before using it again. Refer to your ANTARI dealer or other qualified service personnel. Any other types of fluid can Damage the unit resulting in spitting and serious clogging problem. When filled, place cap back on liquid tank. Firmly attach the remote control cable to the proper input on the back of the machine. Danger of Burns For adult use only and must be installed out of the reach of children. Never leave the unit running Avoid coming within 60 cm of the output nozzle during operation. In order to guarantee adequate ventilation, allow a free air space of at least 20 cm around the sides and top of the unit. the recommended cleaning regimen is as follows: 1. Run unit in a well-ventilated area until tank is almost empty. Run the machine briefly to clear any cleaning solution from the pump and heater. Do not operate the fog machine without liquid at any time. Note: All fog machines are prone to clogging due to the thick consistency of fog liquid and the high temperature at which it vaporizes. However, a properly maintained fog machine should provide years of reliable use. When storing run distilled water (not tap water) through the system as described in the cleaning regimen above. This will help avoid any particles condensing inside the pump or heater. When the fog machine has reached operating temperature the green lamp on this remote control will light up, indicating that the operator may begin fog emission by pressing the red button. The green lamp turns OFF during fog machine warm-up (approx. 4 minutes) amd re-heating cycles (approx. [. . . ] press the yellow TIMERS button to activate the timer function. Adjust the interval between each fog emission (within the range of 10 seconds to 5 minutes) by means of the INTERVAL control knob. Adjust the duration of each fog emission (within the range of 1 to 10 seconds) by means of the DURATION control knob. When pressed, the green MANUAL button overrides all other functions controls, and activates maximum output. [. . . ]