User manual JBSYSTEMS LIGHT TAURUS LED V 1.0

[. . . ] Reproduction or publication of the content in any manner, without express permission of the publisher, is prohibited. Never expose the lens to direct sunlight, even for a short period. This may damage the light effect or even cause fire!EN - DISPOSAL OF THE DEVICE Dispose of the unit and used batteries in an environment friendly manner according to your country regulations. [. . . ] The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Master LED: is lit when the unit is switched as master MENU button: used to select the different menu items DOWN button: to go back in the menu and to lower the values shown on the display. uP button: to go up in the menu and to increase the values shown on the display. ENTER button: used to confirm your choice. MAIN MENU: To select any of the menu options, press the MENU button up to when the required one is shown on the display. Use DOWN and UP button to choose the desired menu option. once the required menu option is selected , press the ENTER button to select. To go back to the functions without any change press the MENU button or just wait 8 seconds. Whit an optional CPB-4 "Centerpiece bracket" you can make a fantastic combination of 4pcs TAURUS led. The result is a superb LED Centerpiece effect, really a must if you want an original and eye-catching effect!Mains input with IEC socket, connect the supplied mains cable here 2. Mains output with IEC socket: you can use a special IEC power cable to connect this output with the mains input of the next TAURUS for easier linking. Hanging bracket with 2 knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook. Slave LED: is lit when the unit is in slave mode 11. Sound LED: blinks to the rhythm of the music while the unit is in audio mode 12. DMX LED: is lit when the unit receives a DMX-signal Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again for about 2seconds. Once the mode is selected, press the ENTER button to setup (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again for about 2seconds. Working Mode Used to set the unit in master or slave mode. press the MENU button until is shown on the display. Press the ENTER button, the current working mode starts blinking in the display Use the DOWN and UP buttons to select M A S T (master) or one of the 4 slave modes: S L 1 S L 4 . [. . . ] Clean the internal optics at least every 90 days. Mains Input: Power consumption: Fuse: Sound Control: DMX connections: DMX channels used: Lamp: Size: Weight: AC 100V - 240V, 50Hz/60Hz 12 Watt 250V T1A slow blow (20mm glass) Internal microphone 3pin XLR male / female 1/3/9/28 channels 84 LEDs (R=21 + G=21 + B=21 + W=21): 246 x 320 x 192 mm 2 kg Every information is subject to change without prior notice You can download the latest version of this user manual on our website: www. Make sure the area below the installation place is free from unwanted persons during servicing. Switch off the unit, unplug the mains cable and wait until the unit has been cooled down. [. . . ]