User manual JBSYSTEMS LIGHT TUBLELED POWER SUPPLY V 1.2

[. . . ] To take full advantage of all possibilities, please read these operating instructions very carefully. This product meets the requirements of the current European and national guidelines. conformity has been established and the relevant statements and documents have been deposited by the manufacturer. TUBELEDTM switching power supply with 2 outputs, each suitable for connecting 8 TUBELEDTM INDOOR units. [. . . ] To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even cause damages. Don't place metal objects or spill liquid inside the unit. No objects filled with liquids, such as vases, shall be placed on this appliance. electric shock or malfunction may result. If a foreign object enters the unit, immediately disconnect the mains power. No naked flame sources, such as lighted candles, should be placed on the appliance. Don't cover any ventilation openings as this may result in overheating. Prevent use in dusty environments and clean the unit regularly. Inexperienced persons should not operate this device. maximum save ambient temperature is 40°C. Don't use this unit at higher ambient temperatures. Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. Never let the power-cord come into contact with other cables! [. . . ] POWER SUPPLY OUTPUT CABLE 1: To be connected with the power input cable of the first tube in a series of 8 tubes. POWER SUPPLY OUTPUT CABLE 2: To be connected with the power input cable of the first tube in a second series of 8 tubes. GROUND CONNECTION: Use this connection to ground the power supply properly. FUSE HOLDER: to be equipped with a 4A/250V slow blow fuse. [. . . ]