User manual JBSYSTEMS LIGHT WD MERGER V 1.0

[. . . ] It is absolutely necessary for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by disregarding this user manual. Keep this booklet in a safe place for future consultation. [. . . ] Inexperienced persons should not operate this device. maximum save ambient temperature is 40°C. Don't use this unit at higher ambient temperatures. Always unplug the unit when it is not used for a longer time or before you start servicing. The electrical installation should be carried out by qualified personal only, according to the regulations for electrical and mechanical safety in your country. Check that the available voltage is not higher than the one stated on the rear panel of the unit. The socket inlet shall remain operable for disconnection from the mains. The power cord should always be in perfect condition: switch the unit immediately off when the power cord is squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard Never let the power-cord come into contact with other cables!This appliance must be earthed to in order comply with safety regulations. In order to prevent electric shock, do not open the cover. Apart from the mains fuse there are no user serviceable parts inside. never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type and electrical specifications!In the event of serious operating problems, stop using the appliance and contact your dealer immediately. Please use the original packing when the device is to be transported. Due to safety reasons it is prohibited to make unauthorized modifications to the unit. CAUTION: To reduce the risk of electric shock, do not remove the top cover. [. . . ] Do not use volatile liquids such as benzene or thinner which will damage the unit. Power Input: Fuse: DMX input: DMX Through: DMX output: Wall dimmer inputs: 100V~ to 240V~ 50/60Hz 20mm glass fuse 250V 1A slow standard DMX-512 standard DMX-512 (1:1 copy of DMX input) only DMX-channels 001 to 024 Wall Dimmer1 = DMX channels 001 to 004 Wall Dimmer2 = DMX channels 005 to 008 Wall Dimmer3 = DMX channels 009 to 012 Wall Dimmer4 = DMX channels 013 to 016 Wall Dimmer5 = DMX channels 017 to 020 Wall Dimmer6 = DMX channels 021 to 024 see drawing 1, 2kg Always switch the unit off and disconnect it from the mains before you make changes in the wiring. The inputs are equipped with press contacts: Strip the wires over 5mm Press button while you insert the wire. Optionally you can connect a DMX controller to the DMX input (3) but be aware that, once a DMX signal is detected, it has priority over the wall dimmer inputs! [. . . ]