User manual JENSEN VOYAGER LCD TVS QUICK REFERENCE GUIDE

[. . . ] Do not mount radio within close proximity of engine compartment. Use the Proper Power Supply This product is designed to operate with a 12 volt DC negative ground battery system. Protect the Disc Mechanism Avoid inserting any foreign objects into the disc slot. Misuse may cause malfunction or permanent damage due to the precise mechanism of this unit. [. . . ] NOTE: The weather band channel frequency is fixed in preset memory and cannot be changed. Select a Band Press the BAND button (16) on the control panel to change between three FM bands and two AM bands. Tuning Rotate the TUNE/ENTER control (22) clockwise or counter-clockwise to tune up or down in one step increments. Therefore, the playing order may not be the same as the order in which they are expected to played. Controlling Disc Playback Selecting Tracks Press the SEEK \/ (19) or SEEK /\ button (20) to advance to the next track on the disc. The selected track number will appear on the display. Press and hold the SEEK \/ (19) or SEEK /\ button (20) to fast forward or fast reverse through the disc. Playback begins when the button is released. For an MP3/WMA disc, press the disc/directory UP or DN button (10, 9) to skip to the following/ previous folder. Play/Pause Disc Playback Press the >/|| button (26) to suspend disc play. Press the >/|| button again to resume disc Play. Previewing Tracks Press the INT button (6) on the control panel to play the first 10 seconds of each track sequentially. Press INT again to stop Intro Scan and resume normal play at the current track. Repeat Play Press the RPT button (5) during disc play to repeat play the current track. Press the AS/PS button again to stop scanning and play the current channel. Preset Tune In Sirius mode, press and hold the AS/PS button (15) to start the Preset Tuning Mode. This will allow the sequential tuning of the SR1, SR2 and SR3 preset channels when the TUNE/ENTER control (22) is used. Press and hold the AS/ PS button again to deactivate Preset Tuning Mode. SIRIUS Tuning Modes 5 6 7 27 8 9 10 Category Mode Press the SEEK/CAT/TRK /\ / \/ buttons (20/19) to view available categories. Switching to SIRIUS Mode Press the MODE button (4) to change the mode to Sirius Satellite Radio mode. Activating Sirius Satellite Radio Before you listen to Sirius Radio, you must subscribe to the service using your radio's identification number. To display the Radio ID, press the SEEK /\ or SEEK \/ button (20, 19) to access channel "000". The screen displays "SID" followed by an 12 figure ID number. Selecting a Band In Sirius mode, press the BAND button (16) to access the Sirius user-preset channel groups in the following order: SIR1, SIR2, SIR3. Each category title and associated channels will be displayed in increments. While in the category mode, the individual channels within a category may be accessed by rotating the TUNE/ENTER control (22). Once a highlighted channel has been selected, press the TUNE/ ENTER control to tune to that channel. While viewing a category list, press the INFO SCROLL button to change display information between Channel Name, Artist, or Song Title. Press and hold the TUNE/ENTER control (22) to switch to Direct Tune/Skip Channel mode. After accessing Direct mode, "DIRECT _ _ _" appears on the display. [. . . ] (Most vehicles employ this wire and resistor, but it may be necessary to check them for correct operation. ) Another method of suppression is the use of additional noise suppressors. These can be obtained from most CB/A radio or electronic supply shops. Interference Radio reception in a moving environment (automobile) is very different from reception in a stationary (home) environment. AM reception will deteriorate when passing through a tunnel or when passing under high voltage lines. Noise can be picked up from passing automobiles. [. . . ]