User manual JENSEN CD-470

[. . . ] The use of controls or adjustment or performance of procedures other than those specified here may result in exposure to hazardous radiation. · Place the unit on a flat and even surface. · Do not restrict the air-flow of the unit by placing it in a place with poor ventilation, by covering it with a cloth or by placing it on a carpet. ON CONDENSATION · When left in a heated room where it is warm and damp, water droplets or condensation may ON PLACEMENT · Do not use the unit in places where are extremely hot, cold, dusty or humid. form inside the unit. · When there is condensation inside the unit, the unit may not function normally. · Let it stand for 1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit before use. [. . . ] When the unit is operated from AC power source, the internal battery source will automatically be disconnected. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT. Set the Function Selector (# 27) to "RADIO". Set the Band Selector (# 26) to "AM" or "FM" for the desired radio band. Turn the Tuning Knob (# 16) to select the desired radio station. Adjust the Volume Control (# 1) to obtain the desired sound level the Built-in Speakers. To turn the Radio off, set the Function Selector (# 27) to the "TAPE" position. TIPS FOR BEST RADIO RECEPTION 1. To insure maximum FM tuner reception, the Telescopic Antenna (# 4) should be fully extended and rotated to obtain the best possible station reception. When tuning in AM reception, be sure to place the unit in a vertical position. To insure best AM reception, try repositioning the unit until the best station reception is obtained. - EN 8 - CD PLAYER OPERATION Note: This CD player will not only play commercial CDs, but also self-compiled CD-R/RW discs. Do not attempt to play CD-ROM, CDI, VCD, DVD or computer CDs. Press the CD Skip Forward Button (# 19) or CD Skip Backward Button (# 20) to select the song to be programmed. 4. 5. 6. 7. 8. Press the PROGRAM Button (#9) again to store selection. The LED Display (#13) will go to "02" and blink to prompt for input. Press the CD Skip Forward Button (# 19) or CD Skip Backward Button (# 20) to select the next song to be programmed and press the CD PROGRAM Button (# 18) to store the second selection. You may repeat steps #2 - #4 to program as many as 20 tracks. The programmed tracks will be shown in the LED Display (# 23) one by one in the programmed sequence after the 20th selection has been stored. To check the programmed tracks, press the PROGRAM Button (# 18) repeatedly until the last Program No. appears and flashes in the Display and then press the PROGRAM Button (# 18) once again. The programmed tracks will be displayed one by one in the programmed sequence. Press the CD PLAY/PAUSE Button (#12) to start playing in the programmed sequence. After all the programmed tracks have been played the player stops but the program remains in the memory. [. . . ] Slowly adjust both the volume controls on your CD-470 and the external device. Set the Function Selector (# 27) to the "TAPE" position to turn CD-470 off and unplug the AUX IN jack USING HEADPHONES (NOT INCLUDED) Inserting the plug of your headphones into the Stereo Headphone Jack (# 28) will enable you to listen to the CD, Radio or Cassette music in private. When using headphones, the Built-in Speakers will be disconnected. READ THIS IMPORTANT INFORMATION BEFORE USING YOUR HEADPHONES 1. [. . . ]