User manual JENSEN CD-540

[. . . ] MODEL CD-540 PORTABLE AM/FM CD CASSETTE RECORDER INSTRUCTION MANUAL Please read this Instruction Manual carefully before using the unit and retain it for future reference IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET REFER SERVICING TO QUALIFIED PERSONNEL ONLY. The Caution marking is located at the bottom of the unit CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS GIVEN IN THIS OWNER'S MANUAL AND THOSE MARKED ON THE UNIT, KEEP THESE INSTRUCTIONS. RETAIN THIS BOOKLET FOR FUTURE REFERENCE. This set has been designed and manufactured to assure personal safety. [. . . ] · Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such as PC performance, writing software, media ability, etc. · Do not attach a label or seal to either side of the CD-R/RW disc. Open the CD Door (# 11) by pressing the Open CD Door Button (# 2). Carefully place an audio CD with its label side upward in the CD compartment and close the CD Door by pressing on the CD Door (# 11) where PUSH CLOSE is indicated. Set the Function Selector (# 27) to the "CD" position. The LED Display (# 23) will briefly display flashing "- -"and then the total number of tracks on the CD will appear in the LED Display (# 23) after a few seconds. The Play/Program Indicator (# 25) will light and the CD will start playing from the first track. Adjust the Volume Control (# 1) to obtain the desired sound level from the Built-in Speakers. To suspend playing, press the CD PLAY/PAUSE Button (#12) and the track No. To resume playing, press the CD PLAY/PAUSE Button (# 12) again. You can choose to play your favorite track directly by pressing either the Skip Forward Button (# 19) or Skip Backward Button (# 20). The LED Display (# 23) will indicate the correct track number selected. To locate a particular passage within a track, keep the CD Search Forward Button (# 19) or CD Search Backward Button (# 20) depressed until it is found. To repeat a particular track, press the CD REPEAT Button (#13) until the CD Repeat 1/All Indicator (# 24) flashes. To repeat the entire CD, press the CD Repeat Button (#13) until the CD Repeat 1/All Indicator (# 24) lights steadily. To stop playing, press the CD STOP Button (#14). When you wish to turn off the CD Player, set the Function Selector (# 27) to the "TAPE" position. 2. CD PROGRAMMED PLAY This function allows the tracks to be played in a programmed sequence. NOTE: Program can only be set in STOP mode. In CD stop mode, press the PROGRAM Button (# 18) once. "01" will appear and blink in the LED Display (#13). Press the CD Skip Forward Button (# 19) or CD Skip Backward Button (# 20) to select the song to be programmed. [. . . ] Solvent or detergent should never be used. Avoid leaving your unit in direct sunlight or in hot, humid or dusty places. Keep your unit away from heating appliances and sources of electrical noise such as fluorescent lamps or motors. If drop-outs or interruptions occur in the music during CD play, or if the CD fails to play at all, its bottom surface may require cleaning. [. . . ]