User manual JENSEN JER-321

[. . . ] Although the RCP 3 operates both products, along with a host of other products you may have added to your system, this manual describes a few differences from the original remotes. The most significant is the addition of EzSet, an automatic speaker-level calibration process that enables the receiver to perform properly without your having to supply additional metering devices or perform a tedious calibration procedure. IMPORTANT NOTE: The instructions in this manual on running the EzSet procedure take the place of Step Four of the Initial Setup process described in the AVR 144 manual. Although you may still calibrate the speakers manually if you so desire, we strongly recommend that you first use the more convenient and simpler EzSet process. [. . . ] It may help to think of the remote as a book with pages. Each page represents the button functions for a different device. In order to access the functions for a particular device, you first need to turn to that page. This is done by pressing the AVR Button to access the codes that control the receiver, or the Input Selector buttons to access the codes for the devices programmed into the remote. At the factory, the codes to control the AVR 144 and DVD 27 are preprogrammed. If you have other source devices in your system, such as a VCR, or a cable or satellite television set-top box, follow these steps to program the correct codes into the remote. Using the codes in Tables A2­A8 of the Appendix, look up the product type (e. g. , DVD, cable TV box) and the brand name of your source. The number(s) listed are potential candidates for the correct code set for your particular device. Put the remote into Program mode by pressing and holding the Input Selector and the Mute button simultaneously until the LED on the remote starts to flash, and then releasing the buttons. You may wish to repeat this process until you've programmed a satisfactory code set that operates most of the functions you frequently use. You may find out which code number you have programmed by pressing and holding the Input Selector and Mute Button simultaneously to enter Program mode. Once you have accepted a code, it's a good idea to try using some other functions to control the device. Sometimes manufacturers use the same Power code for several different models, while other 9 USING EzSET Using EzSet This section replaces Step Four in the Initial Setup section of the AVR 144 owner's guide. An essential step in setting up your multichannel audio/video receiver is calibrating the channel output levels so that they all sound equally loud at the listening position. This sets a baseline, enabling the director to create a desired mood by moving the dialogue, action and ambient sounds around the soundstage, resulting in a more realistic presentation. EzSet takes the guesswork out of the manual process described in the AVR 144 owner's guide, replacing multiple steps with a simple button press. By now you should have connected all of your speakers and sources and your video display. You should have turned on the receiver and used the Manual Setup menus to program each of your speakers as Large or Small. Sit in the listening position with the remote control, and make sure to eliminate external noises for the few minutes needed to run the EzSet procedure. Use the volume control buttons on the remote to adjust the volume to ­15dB. Press and hold the SPL Button until the LED remains steadily lit, then press the "5" key. The procedure works best if you hold the remote at about ear level, pointed toward the receiver. [. . . ] It isn't possible to "edit" a command within a macro. However, you may erase the macro as follows: 1. Simultaneously press and hold the Mute Button and the Macro Button containing the macro until the LED flashes. Press the Surround Button to erase the macro. Resetting the Remote To reset the remote to its factory defaults, simultaneously press and hold any Input Selector and the "0" Numeric Key. [. . . ]