User manual JENSEN JIMS-185 DATASHEET

[. . . ] Over time your hearing "comfort level" adapts to higher volumes of sound. So what sounds "normal" can actually be loud and harmful to your hearing. Guard against this by setting your equipment at a safe level BEFORE your hearing adapts. To establish a safe level: · Start your volume control at a low setting. [. . . ] To manually tune the radio station, press the TUNE + or TUNE - button repeatedly. To automatically scan to the next radio station with the strongest signal, press and hold the TUNE + or TUNE - button for 1-2 seconds until frequency readout on the display begins to scan and then release the button. The tuner will stop scanning when it receives the next strongest station signal. Press the VOLUME+/VOLUME ­ button to ajust the volume to your desired listening level. When you have finished listening, press the "ON/OFF" button to turn off the unit. 10 FM STEREO / MONO RECEPTION 1. This unit provides FM STEREO and FM MONO settings. In stereo mode, the unit will automatically switch to stereo when a FM stereo broadcast is received. To receive a weak (noisy) FM station, press the MONO/STEREO button once to switch the FM mode to "MONO". The FM ST indicator turns off, the reception may be improved, but the sound is now monaural (MONO). When listening to an FM program, fully extend the Wire Antenna to insure maximum tuner sensitivity. The AM receiver uses an external AM loop antenna. Press and hold the button for fast forward / backward setting the alarm time. Press ALARM1 or ALARM2 button again to confirm the ALARM time setting. Press ALARM1 or ALARM2 repeatedly to select wake to ALARM (buZ) , RADIO (rAd), iPod / iPhone (IPod) or turn off the alarm. CHECKING THE WAKE UP TIMES To check the wake up time, simply press and hold the ALARM 1 or ALARM 2 button for 3 seconds. The display will change from current time to wake up time. Release the ALARM button, it will return to current time after 5 seconds. To select wake to radio mode, press the ALARM button you want to set repeatedly until the display shows "rAd". Release the ALARM button and waiting about 3 seconds to confirm. 13 NOTE: The last radio station you listen to will be the same station you will wake to. The radio will automatically turn on and the ALARM indicator will flash when the alarm time is reached. The volume starts softly and becomes gradually louder. The radio alarm will keep sounding for 60 minutes and then automatically shut off and resets for wake up at the same time the following day. [. . . ] The unit does not respond (no power) Wall outlet is not functioning. Solution Plug the AC adaptor into a wall outlet and plug the connector into the supply jack on the unit. Plug another device into the same outlet to confirm the outlet is working. Remove your iPod / iPhone from the dock and check for obstruction on the connectors in the dock and on your iPod/iPhone. Remove your iPod / iPhone from the dock and check for obstruction on the connectors in the dock and on your iPod / iPhone. [. . . ]