User manual JENSEN JIMS-190

[. . . ] DOCKING DIGITAL MUSIC SYSTEM FOR iPod® OWNER'S MANUAL JiMS-190 (iPod® Not Included) PLEASE READ THIS OPERATING MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE TABLE OF CONTENTS DEAR JENSEN® CUSTOMER IMPORTANT SAFETY INSTRUCTIONS COMPLIANCE WITH FCC REGULATIONS PRODUCT FEATURES INSTALLATION LOCATION OF CONTROLS RADIO OPERATIONS iPod® DOCKING AUXILIARY INPUT CLOCK AND CALENDAR SETTINGS ALARM OPERATIONS CARE AND MAINTENANCE TROUBLESHOOTING GUIDE SPECIFICATIONS SERVICE 2 2 3 4 4 5-6 7 8 9 10 11 12 13 14 14 "Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. iPod is a trademark of Apple Inc. , registered in the U. S. and other countries. DEAR JENSEN CUSTOMER Selecting fine audio equipment such as the unit you've just purchased is only the start of your musical enjoyment. [. . . ] The tuner will stop scanning until the strongest signal station is searched. You should turn off the iPod manually or remove it from the unit for better reception. 7 iPod ® DOCKING If the docking port will not be used for an extended period of time, it is recommended to cover the docking port by using the "Dock Cover" insert (included). 1. Use the iPod adaptor included in your iPod and insert it into the docking area. Your iPod can now be inserted into the docking port by placing the connector on the bottom of the iPod onto the connector in the docking bay. Note: Please be careful when seating the iPod into the docking to avoid damaging the 30-pin connector on iPod or docking system. 2. Press the POWER On/Off button to switch on the docking system. 3. Press the FUNCTION button repeatedly until the indicator "iPod" shows on the display. The iPod® will start playing and charging automatically. 4. Select your desired EQ and play mode in your iPod®. 5. Press the VOL +/- button on the docking system to adjust your desired volume level NOTE:The volume level cannot be adjusted by the volume control of your iPod ® after being docked. 6. The iPod® is charging even during playback. NOTE: The iPod will only charge in iPod, AUX, or power "OFF" modes. 7. To remove the iPod® from the unit, press and hold the PLAY/PAUSE button for three seconds to switch off the device and then gently remove it from the docking connector. You may control the playback of your iPod® by: - Press the PLAY/PAUSE button to pause or resume the iPod® playback; - Press the iPod Skip/Search Forward or Backward button to skip to the next or previous song; - Press and hold the iPod Skip/Search Forward or Backward button for fast-forwarding or fast-rewinding during playback. 8 AUXILIARY INPUT The auxiliary input cable and plug are built in the unit and allows users to connect their CD player, MP3 player or other digital audio players to the unit. 1. Keep turning the Cord Retracting Wheel, located at the rear of the unit, to the right and pull out the AUX IN Cable located next to the wheel. 2. Connect the AUX IN Stereo Plug to the Line Out Jack or Headphone Jack of an external audio device (not included). 4. Press the FUNCTION button repeatedly until AUX mode is displayed. The display will show the icon "AUX". 5. Control the volume level by the volume control on the audio device or pressing the VOL +/- on the main unit or the remote control. 9 CLOCK AND CALENDAR SETTINGS The clock and calendar can be set in Power Off mode. Clock Setting 1. Press the MODE button 3 times, the clock starts to flash. 2. Press the TUN +/- button to set the hour. [. . . ] CAUTION: DO NOT USE SHARP, POINTED OBJECT TO PRESS THE RESET BUTTON. IT MAY DAMAGE THE RESET SWITCH INSIDE THE UNIT. RESET button 12 TROUBLESHOOTING GUIDE Symptom Possible Problem AC Adaptor is not plugged into a wall outlet or the connector is not plugged into the power supply jack on the back of the unit. Using no/wrong iPod® Adaptor iPod® does not dock properly Solution Plug the AC adaptor into a wall outlet and plug the connector into the supply jack on the unit. Plug another device into the same outlet to confirm the outlet is working. [. . . ]