User manual JENSEN JIMS-580 DATASHEET

[. . . ] Do not mount radio within close proximity of engine compartment. Use the Proper Power Supply This product is designed to operate with a 12 volt DC negative ground battery system. Before you begin, always disconnect the battery negative terminal. Follow the wiring diagram carefully and make certain all connections are secure to ensure proper operation. [. . . ] If a disc is being inserted when the radio power is off and the ACC (accessory switch) is on, the unit will automatically power up and playback will start. If a CD is present, playback resumes at the last position in memory before the ignition was turned off or the POWER button was pressed. If no CD is present, the unit will resume at the last mode selected (Tuner, Aux, etc. The POWER button is illuminated whenever the IGN lead (red wire) is powered, regardless of whether the unit is on or off. Press and hold the AUDIO button (3) for more than 3 seconds to enter the system menu. "MENU" will appear on the display, followed by the first menu item, "CONTRAST. Press the AS/PS button to return to the previous operation immediately or wait for 5 seconds to return automatically. DISTANT/LOCAL: Select LOCAL for tuner to access local stations whose signals are much stronger. BEEP TONE (ON/OFF): Turn the audible beep ON/OFF (heard when functions/buttons are selected). NOTE: Beep tone off will not affect LOW BATT audible tone. The following items can be adjusted: · The reset button (18) should be activated for the following reasons: · If LOW BATT is set to "ON", a alarm will sound (8 beeps every 30 sec) when the voltage drops to 10. Use the VOLUME +/- buttons (2) to select a number for each position. Press the MODE button for each digit to enter "000". This will display the Sirius ID number for your tuner. The Sirius ID number will scroll twice and then freeze with the first 11 digits on the display. Each category title and song title will be displayed in increments. While in the category mode, press the CAT - /+ buttons again to view category names. (The lowest channel number within the chosen category will always be the default first channel tuned. This unit is equipped with an iPod ready function that will allow you to control your iPod (if compatible) using the control panel control buttons. The following iPod versions are supported: · Repeat Play During playback, press the 3/RPT button (5) to repeat the current song. "Repeat" will appear on the LCD. Press 3/RPT again to stop repeat playback. [. . . ] Use the VOLUME +/- buttons (2) to navigate through various list selections. NOTE: The iPod will continuously recharge when connected to the unit, as long as the vehicle ignition is turned on. Please note that the MSR2010 will not support charging of the iPod Nano 4th generation (Chromatic) or any iPod models released after September 2008. If it does get wet, wipe it dry immediately. [. . . ]