User manual JENSEN JISS-250I

[. . . ] 7. 1 COMPLIANCE WITH FCC REGULATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Fold out the STANDS located on the bottom of JiSS-250i. Select a suitable adaptor attachment for your iPod/iPhone and insert it into the docking tray. Your iPod/iPhone can now be inserted onto the dock connector by aligning the connector on the bottom of the iPod onto the connector in the docking bay as shown below. For iPod/iPhone Landscape Viewing (iPod nano (4th gen), iPod touch, iPhone 2G, and iPhone 3G) proceed as below: 3. Choose the Correct adaptor to hold the iPod/iPhone and embed it at the iPod docking tray. Extend the Speaker by pulling out the Left and Right Speaker Insert the iPod firmly on the docking, now the iPod can be rotated freely into the Landscape position to the Left as shown. Note: - Please be careful when seating the iPod/iPhone into the docking to avoid damaging the 30-pin connector on the iPod or in the docking system. -The iPod/iPhone will start charging immediately when it is docked. - The iPod/iPhone will only be charged when the device is powered by an AC adaptor. Turn the JiSS-250i on by pressing the STANDBY Button on the front panel. Follow the iPod/iPhone operation instructions to operate your iPod/iPhone. Adjust the sound level by pressing the VOL +/- buttons on the JiSS-250i. Note: The volume level cannot be adjusted using the volume control on your iPod after docking. To remove the iPod/iPhone from the unit, press and hold the PLAY/PAUSE Button for few 5 seconds to switch off the device and then gently remove it from the docking connector. To turn JiSS-250i off, press the STANDBY Button again. The System will automatically enter sleep mode 5 minutes after playback stops and switch to standby mode automatically after 30 minutes of no activity. In Sleep mode the LED will flash and in standby mode, the LED will go off. The AUX In function is in higher priority than the iPod function. [. . . ] When returning the unit, please remove any batteries to prevent damage to the unit in transit and/or from possible battery leakage. Please note that we are not responsible for batteries returned with the unit or for the cost of replacement of batteries. Distributed by: Spectra Merchandising International, Inc. [. . . ]