User manual JENSEN JTA-220

[. . . ] 10. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. [. . . ] REMARK: Make sure that the INTERNAL SPEAKER Switch (11) is in "ON" position if external speakers are not connected. HEADPHONE JACK (PHONES) This unit will accept stereo headphones (not included) with a 1/8" plug and an impedance of 32 ohms or greater. The speakers are automatically disconnected when headphones are connected to the PHONES jack. ATTENTION: This unit is designed to operate only on normal 120V 60Hz AC house current. Operating this unit from any other power source may cause damage to unit and such damage is not covered by your warranty. This unit has a polarized AC plug with one wide blade and one narrow blade. This plug will only fit into a matching polarized AC outlet. This is a safety feature to reduce the possibility of electric shock. If this plug will not fit in your AC outlet, you probably have an out dated non-polarized outlet. You should have your outdated outlet changed by a qualified licensed electrician. Do not file the wide blade on the plug, or use an adapter to make the plug fit into your outlet. This defeats the safety feature and could expose you to electric shock. GENERAL POWER BUTTON(3) ­ Press to turn unit on or off. The Power Indicator (4) will light when the unit is on. VOLUME CONTROL(1) ­ Adjusts the volume level of the speakers or headphones. FUNCTION SELECTOR(5) ­ Use to select the desired signal source (AM/FM/FM. ST or PHONO) to be listened to. 2 3 HXT-1058 IB JENS 001 REV0. P65 2 5/9/2006, 4:03 PM TUNER OPERATION 1) Turn on the unit by pressing the POWER BUTTON (3), the Power Indicator lights. 2) Select the desired band (AM/FM/FM St. ) with the FUNCTION Control (5). 3) Tune in your desired station using the TUNING Knob (7). band was chosen, the FM STEREO indicator (6) will light up whenever a stereo broadcast is received. To receive a weak (noisy) FM station, select FM band by setting the FUNCTION knob(5) to the FM position . The FM STEREO indicator (6) will go off and the reception may be improved, but the sound is now monaural (MONO). 4) Adjust the VOLUME Control (1) to the desired sound level. 5) To turn the unit off, press the POWER Knob (3) again, The Power Indicator (4) goes off. [. . . ] Lift the tone arm (12) and return it to the rest (13). IMPORTANT: Do not turn or stop the Turntable platter manually. Moving or jarring the Turntable platter without securing the Tone Arm Clamp could result in damage to the Tone Arm or Stylus. SERVICE CARE & MAINTENANCE - Do not plug in the power cord until all other connections have been made. Power Button After using the unit, switch off the power by releasing the POWER Button. [. . . ]