User manual JENSEN JTA-380 DATASHEET

[. . . ] This set has been designed and manufactured to assure personal safety. Improper use can result in electric shock or fire hazard. The safeguards incorporated in this unit will protect you if you observe the following procedures for installation, use and servicing. This unit does not contain any parts that can be repaired by the user. [. . . ] Slide the FUNCTION Selector (12) to the "TUNER" position. Slide the BAND Selector (11) to either AM, FM or FM ST (FM Stereo Mode). Rotate the TUNING CONTROL (10) until you reach the radio station you wish to listen to. The radio station frequency shows on the LCD DISPLAY. Adjust the sound level by rotating the VOLUME CONTROL (23). To turn off the radio, Slide the FUNCTION Selector (12) to the "OFF" position. The LCD DISPLAY will go "off". FM STEREO RECEPTION " will With the BAND Selector (11) in the "FM ST" position, the FM Stereo Indicator " light up when listening to a strong station that is broadcasting in "Stereo". Slide the BAND Selector (11) to the FM position if the FM stereo reception is weak. The reception may improve, but the sound is now monaural (MONO). 6 TIPS FOR BEST RECEPTION AM ­ The AM antenna is located inside the cabinet of the main unit. If AM reception is weak, change the position of cabinet until the internal antenna picks up the strongest AM signal. FM ­ During FM reception, always keep the FM Wire Antenna fully extended. Insert a USB flash drive into the USB PORT (22) or an SD/MMC Memory Card into the SD/MMC Slot (20) located on the front panel. Press the RECORD Button (17), "REC" and "USB" will begin to flash in the display, If a USB Flash Drive is inserted. If an SD/MMC Card is inserted then "REC" and "CARD" will flash in the display. If both USB and SD/MMC card are inserted, then Icon "SEL" will also appear and flash in the Display. You can use the SKIP + Button (18) or the SKIP - Button (19) to select what media you want to record to. Select the track to be encoded and start playing the record. Press the Record button to start sync encoding. The following will be displayed depending on what media you are using to store the music. Encoding to USB 6. Encoding to Card To stop encoding press the STOP/USB/SD Button (15). Note: To ensure the encoding is successful, remove the USB or Card a few seconds after pressing the STOP Button. To start recording again, press the RECORD Button (17) again and follow step #2 above. 7. PLEASE NOTE : If you want to encode an entire side of a record and have seperate MP3 files for each track, you must manually press the STOP/USB/SD Button (15) at the end of each track and then press the RECORD Button (17) again to start recording the next track. If you do not manually Stop and Start the recording process after each track, you will end up with one large MP3 file that will have all the songs from the side of the record playing one after the other. 8 USB / CARD OPERATION The following tasks can be accomplished by either using the controls on the REMOTE Control or those which have similar function markings on the JTA-380 main unit. [. . . ] Select the music source by setting the Function Selector (12) to "PHONO", "USB/SD" or "TUNER" as desired. Turn on the external Amplifier. 12 4. 7. Sound will then come out from the system's built-in speakers and the external Amplifier's speakers simultaneously. Set the VOLUME CONTROL (23) to "MIN" and adjust the sound level using the VOLUME CONTROL on the external Amplifier as desired. [. . . ]