User manual JENSEN JTA-450

[. . . ] JTA-450 3-SPEED STEREO TURNTABLE WITH MP3 ENCODING AND AM/FM STEREO RADIO INSTRUCTION MANUAL PLEASE READ THIS OPERATING MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN IT FOR FUTURE REFERENCE. IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET REFER SERVICING TO QUALIFIED PERSONNEL ONLY. CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS GIVEN IN THIS OWNER'S MANUAL AND THOSE MARKED ON THE UNIT, KEEP THESE INSTRUCTIONS. RETAIN THIS BOOKLET FOR FUTURE REFERENCE. [. . . ] Press the BASS BOOST Button (13) again (button out) to turn the Bass Boost off. Note : Please refer to the ON/OFF graphic on the Front Panel for correct operation of the Bass Boost function. PLAYING PHONO RECORDS Raise the Turntable Dust Cover. Remove the stylus protector and release the Tone Arm Clamp (6). Slide the Function Selector (12) to "PHONO". Place a record on the turntable, over the center spindle. Set the Speed Selector Switch to 33, 45 or 78 rpm according to the record you are playing. Place the included 45 RPM adaptor (2) over the center spindle when playing 45 rpm records. Move the Tone Arm to the beginning of the record or to the beginning of a particular track. Gently lower the Tone Arm onto the record to start playing. The Turntable will stop automatically when the record finishes. To stop the record before it ends, lift the Tone Arm (4) using the Cue-lever (3) and return it carefully onto the Tone Arm Clamp (6). Replace the stylus protector on the stylus when not in use. Do not stop or turn the platter manually. Moving or jarring the turntable without securing the Tone arm clamp could result in damage to the Tone arm. AUTO-STOP SWITCH OPERATION The Auto-Stop area on some records may extend beyond the preset setting. As a result the turntable could possibly stop before the last track finishes. If you experience this during playback, set the AUTO-STOP Switch (27) located on the back of the unit to the "OFF" position. The turntable will now run to the end of the record, but will no longer stop automatically. To stop the turntable you will need to either set the Function Selector (12) to the OFF position or return the AUTO-STOP Switch (27) to the "ON" position. After the record stops, lift and return the Tone Arm (4) carefully back onto the Tone Arm Clamp (6). 7 IMPORTANT: Moving or jarring the Turntable without securing the Tone Arm Clamp (6) could result in damage to the Tone Arm (3). ENCODING RECORDS TO MP3 You can convert you favorite records into MP3 files and store then on a USB Flash Drive or SD/MMC Memory Card via the USB port (22) or SD/MMC slot (20) located on the front panel. Insert a USB flash drive into the USB PORT (22) or an SD/MMC Memory Card into the SD/MMC Slot (20) located on the front panel. Press the RECORD Button (17), "REC" and "USB" will begin to flash in the display, If a USB Flash Drive is inserted. [. . . ] Turn the System and the external Amplifier off when you have finished listening. Unplug the connection cable. USING HEADPHONES (NOT INCLUDED) This System accepts stereo headphones with a 3. 5mm plug and an impedance of 8 ohms or greater. Inserting the plug of your headphones into the Headphone jack (21) will enable you to listen privately. When using headphones, the speakers will be disconnected automatically. [. . . ]