User manual JENSEN JWM-120 DATASHEET

[. . . ] Install support strap to make unit more stable. Function LF+ Speaker LF­ Speaker LR+ Speaker LR­ Speaker RF+ Speaker RF­ Speaker RR+ Speaker RR­ Speaker Power Antenna Ground Ignition Battery Color white white/black green green/black gray gray/black violet violet/black dark blue black red yellow Auxiliary Input Cables Connect a pre-amp level external audio source (MP3, tape player, etc. Power Antenna Connect to power antenna or amplifier. Memory/Battery Connect to battery or 12 volt power source that is always alive. [. . . ] The radio will not work if this wire is not connected. Fuses When replacing a fuse, make sure new fuse is correct type and amperage. Using an incorrect fuse could damage radio. This unit uses one 15 amp fuse located below wiring connector. Replace any items you removed from the dashboard. When wiring is complete, reconnect the battery negative terminal. Does not operate (display does not light) No power to yellow wire No power to red wire Make sure wire is not pinched. Inline fuse blown No power to unit No speakers operate (display lights normally) Not all speakers operate Inline fuse blown Speaker harness not connected Incorrect splices or connections Speaker wires shorting to chassis ground or to each other Blows fuses Power wire shorting to ground Speaker wires shorting to ground Incorrect fuse/ fuse too small CD skips too much Receiver mount is not solid or backstrap is not secure Check disc - may be upside down or dirty If not press RESET button. CDC ONLY ERR2 appears on display TOC reading error Check disc - may be upside down or dirty If not press RESET button. Press PWR for more than 3 seconds to store level. Radio pauses for five seconds at each strong station. Do not expose CD player to extremely high or low temperatures. ⷠDo not drive with ejected CD in the slot. Power does not have to be on to eject CD. Repeat the Same Track Press RPT for more than three seconds to continuously repeat same track. Press again for more than three seconds to stop repeat. Random (Play all Tracks) Press RDM for more than three seconds to play all tracks on CD in random order one time. Press again for more than three seconds to stop random play. Intro (Preview all Tracks) Press INT for more than three seconds to play first ten seconds of each track on current CD. Press again for more than three seconds to stop intro and listen to track. [. . . ] Press again for more than three seconds to stop intro and listen to track. Select first track to be entered into program. Then momentarily press MEM to enter them into the program. Press PGM for more than 3 seconds to play programmed tracks. [. . . ]