User manual JENSEN SAB-55

[. . . ] If the unit does not operate, recheck all wiring until the problem is corrected. Once proper operation is achieved, turn the ignition switch off and proceed with final mounting of the chassis. Carefully slide the radio into the mounting sleeve making sure it is right-side-up until it is fully seated and the spring clips lock it into place. Attach one end of the perforated support strap Dashboard (supplied) to the screw stud on Support Strap the rear of the chassis using the hex nut and spring washer Plain Washer provided. [. . . ] Fasten the other end Screw (4 x 12mm) of the perforated strap to a secure part of the dashboard Screw Stud Hex Nut (5mm) either above or below the radio using the screw and plain Spring Washer washer provided. Bend the strap, as necessary, to position it. CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from the weight of the radio or improper operation due to vibration. Re-attach the front panel to the chassis and test radio operation by referring to the operating instructions for the unit. Removing the Unit To remove the radio after installation: 1. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When re-attaching the frame, point the side with a groove downwards and reattach. ) Insert the removal keys straight back until they click, and then pull the radio out. If removal keys are inserted at an angle, they will not lock properly to release the unit. Important Notes DIN Front/Rear Mount This unit can be property installed with either a "Front" (conventional DIN front mount) or "Rear" (DIN rear mount installation, utilizing threaded screw holes at the sides of the unit chassis) mount. For details, refer to installation methods A and B. Remove the detachable front panel, if it is Dashboard attached to the chassis, by pushing the Bend Tabs REL button. Do not Factory exceed M5 x 9 MM maximum Mounting screw size. Longer screws Bracket may damage components Hook (Remove) inside the chassis. Wire the new radio to the vehicle as outlined in the Universal Installation instructions. Mount the new radio assembly to the dashboard or center console using the reverse procedure of step 1. 4. 5. NOTE: The mounting box, outer trim ring, and half-sleeve are not used for method B installation. Reconnect Battery When wiring is complete, reconnect the battery negative terminal. 4 0 MCD5070 SPECIFICATIONS CD Signal to Noise Ratio. 2 Channel (Stereo) FM Radio Frequency Range . > 15dB at S/N 30dB Stereo Separation . 40W x 4 No sound TROUBLESHOOTING Symptom No power Cause The vehicle's ignition is not on The fuse is blown Solution If the power supply is properly connected to the vehicle accessory terminal, switch the ignition key to "ACC". Remove the disc in the player and insert the new one. Insert the compact disc with the label facing upward. [. . . ] Remove the disc in the player and insert the new one. Insert the compact disc with the label facing upward. Clean the disc or try to play a new one. Wait until the ambient temperature returns to normal. [. . . ]