User manual JENSEN SMPV-XGBEF DATASHEET

[. . . ] These seals are used to keep dust and water out of the unit. After removing the three transport lock screws, place three pieces of the small plastic film (supplied) over the three screw holes to prevent water entry. To prevent a short-circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. NOTE: If the changer is to be installed in a vehicle equipped with an on-board drive or navigation computer, do not disconnect the battery cable. [. . . ] Do not use any of the screws that are part of the brake or steering system to install the unit. Be careful not to snag any wires when tightening screws. This unit cannot be installed on its side, end, or upside down. Make certain the changer is easily accessible for loading and unloading the CD magazine. The 15 foot long data cable will reach the radio connection when routed from the changer. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective, and vibration may cause the disc to skip. Set the antivibration board position with a screwdriver before attaching the brackets. After setting the proper angle before installation, place two pieces of the larger plastic film (supplied) over the built-in anti-vibration boards to prevent water entry. Never mount the unit near the fuel tank. Make sure the anti-vibration springs are set to position "0". Attach a bracket (A) to each side of the unit using the machine screws (M4x5). Make sure the anti-vibration springs are set to position "45". Attach a bracket (A) to each side of the unit using the machine screws (M4x5). Attach the brackets (A) to the mounting base (B) using the hexagonal bolts (M6x12) and M6 flat and split washers. Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. Affix the unit to the floor by pressing in place. Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion. Affix the unit to the floor by pressing in place. Quite los pernos hexagonales adhiriendo los soportes (A) a la base de montaje (B) y quite el cambiador de la base (Paso 3 para referencia). Using a knife, cut holes in the carpet directly above the bracket's bolts. Mettez la bande à deux faces fournie en bas des bases de montage (B) et éplucher le support en papier. [. . . ] First, connect the right-angle connector end of the data cable to the 8-pin socket on the back of the changer. When routing wires and cables from the changer to the radio, it is best to conceal the wires. When wiring is complete, reconnect the battery negative terminal. Grip the tab on the magazine tray into which you will be loading a disc and pull it out gently. [. . . ]