User manual JENSEN UV9

[. . . ] We hope you will find the instructions in this owner's manual clear and easy to follow. If you take a few minutes to look through it, you'll learn how to use all the features of your new Jensen Phase Linear UV9 Mobile Multimedia Receiver for maximum enjoyment. Congratulations on your purchase of the Jensen Phase Linear UV9 Mobile Multimedia Receiver. It's a good idea to read all of the instructions before beginning the installation. [. . . ] The TFT panel automatically opens when the unit is turned on. you must press the OPEN button (1) to open the TFT panel. When the ignition is turned OFF, the TFT panel DOES NOT retract if it was previously out Touch the top left corner of the screen (the RADIO circle) to view the SOURCE MENU. Enter the desired radio station using the on-screen number pad. press the Enter button to tune to the selected station. To exit the screen without changing the station, touch Exit. To clear your entry and start over, touch Clear. Touch the BAND button (15) on the screen, or press the BAND button on the remote control (18) to change between the following bands: FM1, FM2, FM3, AM1, and AM2. NOTE: The BAND button on the unit only works when the TFT is closed. Touch the preset number in which you would like to store the current station (or touch Exit to cancel and close the menu). Current radio band indicator Radio frequency indicator Clock Stereo broadcasting indicator Strong Local signal broadcasting indicator Preset radio stations: Touch to recall preset stations Information about the current function Touch for quick access to Equalizer level settings Touch to access the direct entry screen Current preset station indicator |<<: Touch to seek backward >>|: Touch to seek forward <<: Touch to tune backward one step >>: Touch to tune forward one step BAND: Touch to change between AM/FM bands AS: Touch to automatically store stations Touch to view the SOURCE MENU and select a new playback source 18. MEM: View screen used to enter current channel into preset memory 19. PS (Preview Scan): Touch to scan all stations available, stopping for 5 seconds at each and continuing until a station is selected To enter a radio station directly, touch the button or press the GOTO button (19) on the remote control to display the direct entry menu. Auto Store (AS) To select six strong stations and store them in the current band: 1. Press the AS button (3) on the control panel or touch AS (16) on the screen for 2 seconds to activate the Auto Store function. The new stations replace stations already stored in that band. Preview Scan (PS) To scan the AM or FM band for a preview of available stations in your particular area, touch the PS button (20). When the Local function is on, only radio stations with a strong local radio signal are played. to activate the Local function in AM/FM tuner mode , press and hold the rotary encoder button (11) on the front panel. Press and hold the rotary encoder again to turn Local off. NOTE: When properly installed, DVD video cannot be displayed on the main TFT screen unless the parking brake is applied. If you attempt to play a DVD while the vehicle is moving, the TFT screen displays "PARKING" with a blue background. [. . . ] If the temperature inside the player gets too hot, a protective circuit automatically stops play of the disc. If this occurs, allow the unit to cool before operating the player again. Never insert anything other than a 5" (12 cm) compact disc into the player as the mechanism can be damaged by foreign objects. Do not attempt to use a 3" (8 cm) CD-Single disc in this unit, either with or without an adaptor, as damage to the player and/or disc may occur. [. . . ]