User manual JENSEN VOYAGER VCCS150B

[. . . ] Ideal applications include but are not limited to home, car, boat or recreation vehicle (RV). Ideal for use on hunting or camping trips, skiing trips, trips to the mall or at your place of business for security patrols or warehouse communication. FEATURES - Includes Charger, 4 GMRS radios and rechargeable batteries - 12VDC power Input - Wall-mount design with integrated 4-screw flange mounting system. - Latching spring-loaded door - LED Charge Status Indicators PERFORMANCE Your transceiver will achieve maximum operating range when communicating with another transceiver in a flat open area with no trees or buildings obstructing it's signal. [. . . ] Pressing any of the buttons will illuminate the display and exit the battery saver mode. USE 1) Install the transceivers with the PTT (Push To Talk) switch facing out. There are four docking bays in the GMRS4WM charger to accommodate up to four GMRS100 Handsets. The latch can be engaged by gently pressing against the center of the door. 3) There are four indicator lights on the GMRS4WM door. Initially they will "glow" red when power is applied (ignition switch in "On" or "ACC" position). After the GMRS100 (Transceiver Handset) batteries are fully charged, the indicators will turn green, indicating the transceivers are ready for use. If the indicator light blinks red, try removing the handset and re-inserting it into the charger unit. 4) The transceivers may be stored safely in the GMRS4WM charging unit. When the batteries are fully charged, each transceiver will individually switch to "trickle" mode. FUNCTION AND LOCATION OF CHARGER CONTROLS 1) Mounting screw locations ­ 4 places Use the mounting screws provided to mount the charger unit to the wall. 2) Handset Compartment Indicators Indicates which handsets (transceivers) are in the unit. FUNCTION AND LOCATION OF HANDSET(GMRS4WM) CONTROLS 1. Push-To-Talk (PTT) and Function Confirmation Button 5. External Speaker (SP)/ Microphone (MIC)/CHG Jack 7. Battery Charging Contacts Controls: Power On-Off/SCAN Button (13) Press and hold the PWR on/off button for at least 2 seconds. You will hear a confirming melody to indicate the unit is on. To turn the unit off, press and hold the button for at least 2 seconds. Adjusting the Volume (11, 10) With the unit powered on, press the Up Channel/Volume button () to increase volume and the Down Channel/Volume button () to decrease volume. The display will indicate the current volume level (VL) followed by the number (0-7). As volume is increased upward, the unit will beep at each step, and vice-versa. When the minimum and maximum volume settings are reached, a unique tone will sound. Monitor/Display Backlight Button (2) This button is used to to check activity on the current frequency before transmitting. Check activity by pressing the Monitor (M) Button longer than 2 seconds; the icon will apppear on the display and you will hear static if frequency is clear. [. . . ] When in function edit mode this button will be used to adjust the unit's settings. MODE Button (12) This button is used to select various feature settings in the GMRS and FRS modes. External Speaker (SPK)/ Microphone (MIC)/CHG Jack (6) This jack accepts both the optional Audiovox headset/microphone connector. For additional equipment and accessories for the GMRS100, visit the Audiovox web site at www. audiovox. com http://www. audiovox. com/ Scan Button (13) With the unit in standby mode, press the Power On/Off Button momentarily to enable or disable the scan function; SCAN will appear on the display. [. . . ]