User manual JENSEN VOYAGER VOM-58

[. . . ] Do not mount radio in close proximity of the engine compartment. Use the Proper Power Supply This product is designed to operate with a 12 volt DC negative ground battery system. Protect the Disc Mechanism Avoid inserting any foreign objects into the disc slot. Misuse may cause malfunction or permanent damage due to the precise mechanism of this unit. [. . . ] If it Bend Tabs is locked into position, use the removal 182 keys (supplied) to disengage it. The removal keys are depicted in "Removing 53 the Unit" on page 3. Screw Stud Check the dashboard opening size by sliding the mounting sleeve into it. If the opening is not large enough, carefully cut or file as necessary until the sleeve easily slides into the opening. Do not force the sleeve into the opening or cause it to bend or bow. Check that there will be sufficient space behind the dashboard for the radio chassis. Locate the series of bend tabs along the top, bottom and sides of the mounting sleeve. With the sleeve fully inserted into the dashboard opening, bend as many of the tabs outward as necessary to firmly secure the sleeve to the dashboard. Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve. Follow the wiring diagram carefully and make certain all connections are secure and insulated with crimp connectors or electrical tape to ensure proper operation. After completing the wiring connections, turn the unit on to confirm operation (vehicle ignition switch must be on). Fader Use the button to adjust the Fader between the rear and front speakers from "10R" (full rear) to "10F" (full front). "FAD R=F" represents an equal balance between the front and rear speakers. BND SCN MOD 8 7 9 12 13 MO P AU MUT SCN DISP RPT Mute Press the MUTE button (8) on the control panel (or the MUT button on the remote control) to mute the audio output. "Mute" will appear on the display. Press MUTE again to restore the audio output to the previous level. Loudness Control (LOUD) When listening to music at low volume levels, this feature will boost the bass and treble ranges to compensate for the characteristics of human hearing. Press and hold the BAND/LOUD button (21) to activate this feature. "LOUD ON" appears on the display panel. Press the BAND/ LOUD button (21) again to turn the LOUD function off. 1 2 3 4 SHUF 5 6 Mode Press the MODE button (5) on the control panel (or the MOD button on the remote control) to select a different mode of operation, as indicated on the display panel. Available modes include Radio, CD, and AUX In (optional Auxiliary Input). Connect the external signal to the "Aux In" jack (20) located on the front of the control panel. If you have a device connected to the rear auiliary input, the front auxiliary device will override the rear one. Press the MODE button to select Aux In mode. Audible Beep To turn on/off the audible beep heard when a function is selected, press and hold the AUDIO control button (4) on the control panel (or the S button on the remote control) to access the Beep option. [. . . ] Manual Tuning Press the TUNE up (19) or TUNE down button (18) for more than three seconds to enter manual tuning mode. Press the TUNE up or TUNE down button to change the radio frequency number up or down one step. Scan Press the SCAN button (22) on the control panel (or SCN on the remote control) to automatically search for stations. Each available station will flash on the display for a few seconds before the next is searched. To select a "flashing" station, press the SCAN button again. Preset Stations Six numbered preset buttons store and recall stations for each band. [. . . ]