User manual JETWAY 939GT4SLIR311

[. . . ] 939GT4-SLI-D 939GT4-SLI -G / 939GT4-SLI -P USER'S MANUAL M/B For Socket 939 64-bit & Dual Core Ready AMD Athlon64FX Processor NO. G03939GT4SLIR311 Rev:3. 0 Release date: June 2005 Trademark: * Specifications and Information contained in this documentation are furnished for information use only, and are subject to change at any time without notice, and should not be construed as a commitment by manufacturer. TABLE OF CONTENT USER'S NOTICE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii MANUAL REVISION INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii COOLING SOLUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ii CHAPTER 1 INTRODUCTION OF 939GT4SLI ­D/939GT4SLI­G/939GT4SLI­P MOTHERBOARD 1-1 1-2 1-3 1-4 2-1 2-2 2-3 FEATURE OF MOTHERBOARD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1-1. 1 SPECIAL FEATURES OF MOTHERBOARD. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 SPECIFICATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] If the controller of HDD interface is SCSI, the selection shall be "None". If the controller of HDD interface is CD-ROM, the selection shall be "None" The settings are Auto Normal, Large, and LBA. Access Mode number of cylinders Cylinder number of heads Head write precomp Precomp Landing Zone landing zone number of sectors Sector 3-5 Advanced BIOS Features Phoenix ­ AwardBIOS CMOS Setup Utility Advanced BIOS Features Removable Device Priority Hard Disk Boot Priority Virus Warning L1 Cache L2 Cache Quick Power On Self Test SATA &SCSI Boot Order First Boot Device Second Boot Device Third Boot Device Boot other Device Swap Floppy Drive Boot Up Floppy Seek Boot Up NumLock Status Typematic Rate Setting Typematic Rate (Chars/Sec) Typematic Delay (Msec) Security Option APIC Mode MPS Version Control For OS OS Select For DRAM > 64MB HDD S. M. A. R. T. Capability Report No FDD For Windows Small Logo (EPA) Show Press Enter Press Enter Disabled Enabled Enabled Enabled SATA, SCSI Floppy HDD-0 CDROM Enabled Disabled Enabled On Disabled 6 250 Setup Enabled 1. 4 Non-OS2 Disabled Yes Enabled Item Help Menu Level > Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help F5:Previous Values F6:Optimized Defaults F7:Standard Defaults 24 Removable Device Priority The selection is for you to choose the removable devices (Such as USB floppy or other related accessories) priorities to boot from. Hard Disk Boot Priority The selection is for you to choose the hard disk drives priorities to boot from. Virus Warning Allows you to choose the VIRUS Warning feature for IDE Hard Disk boot sector protection. If this function is enabled and someone attempt to write data into this area, BIOS will show a warning message on screen and alarm beep. Disabled (default) No warning message to appear when anything attempts to access the boot sector or hard disk partition table. Activates automatically when the system boots up causing a warning Enabled message to appear when anything attempts to access the boot sector of hard disk partition table. CPU Internal Cache The default value is Enabled. Enabled (default) Enable cache Disable cache Disabled Note: The internal cache is built in the processor. External Cache Choose Enabled or Disabled. This option enables the Level 2 cache memory. Quick Power On Self-Test This category speeds up Power On Self Test (POST) after you power on the computer. BIOS will shorten or skip some check items during POST. Enabled (default) Enable quick POST Normal POST Disabled First/Second/Third/Fourth Boot Device The BIOS attempts to load the operating system from the devices in the sequence selected in these items. The settings are Floppy, LS/ZIP, HDD-0/HDD-1/HDD-3, SCSI, CDROM, LAD and Disabled. Swap Floppy Drive Switches the floppy disk drives between being designated as A and B. Boot Up Floppy Seek During POST, BIOS will determine if the floppy disk drive installed is 40 or 80 tracks. 360K type is 40 tracks while 760K, 1. 2M and 1. 44M are all 80 tracks. Boot Up NumLock Status The default value is On. Off 25 Typematic Rate Setting Keystrokes repeat at a rate determined by the keyboard controller. [. . . ] Setup shadow RAM - Enable shadow according to Setup. Init 8259 channel 1 and mask IRQ 9 Quick Memory Test Detect CPU speed and display CPU vendor specific version string and turn on all necessary CPU features Display PnP logo and PnP early init Setup virus protect according to Setup. If required, will auto load Awdflash. exe in POST Initializing onboard superIO 67 KBC and CMOS Init 68 Video Init 69 6A 6B 8259 Init Memory test CPU Detect and IO init 6C 6D 6E 6F 70 Reserved Reserved Reserved Reserved Setup Init 71 72 Setup Cache Controller Install FDD Display setup message and enable setup functions Detect if mouse is present, initialize mouse, install interrupt vectors. Special treatment to PS2 Mouse port ACPI sub-system initializing Initialize cache controller. [. . . ]