User manual JETWAY B 860T

[. . . ] 1 B 860T USER'S MANUAL M/B For Socket 370 Pentium® III Processor NO. B860T Release date: March 2002 Trademark: *Pentium and MMX are trademarks of Intel Corporation. * All the names and brands are the property of their respective owners. *Specifications and Information contained in this documentation are furnished for information use only, are subject to change at any time without notice, and should not be construed as a commitment by manufacturer. 2 TABLE OF CONTENT USER'S NOTICE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The red wire should be positive, while the black one should be ground. Connect the fan's plug to the board according to the polarity of connector. (5)IR infrared module Headers (10-pin) : JI1 This connector supports the optional wireless transmitting and receiving infrared module. To use the IR function, you must configure the setting through the BIOS setup. 19 (6)CD Audio-In Headers (4-pin) : J10 This header is for the CD-ROM Audio connector. (7)Line-in Headers (4-pin) : J6 This header is for Line-in connector. (8)Audio-In/Out Headers (5-pin) : J7 The Audio-in header is for MIC-in connector. The Audio-out header is for Line-out connector. 20 (9)DOC socket : U13, JD1 DOC 32pin dip socket can support flash disk up to 288MB DOC address can select among three address: D000-D1FFh , D800-D9FFh, DE00- DFFFh. 2-7 Start Up Your Computer 1. After all the connections are made, close the chassis cover. Be sure all the switches are off and check if the power supply input voltage is set at the proper position. Usually the in-put voltage is 220V~240V or 110V~120V, depending the country. Connect the power supply cord into the power supply located on the back of your system case according to the user's manual of your system. Turn on your peripherals as the following orders: a. Other external peripherals (Printer, Scanner, External Modem etc. . . ) c. For ATX power supplies, you need to turn on the power supply and press the ATX power switch which is on the front panel of the case. The power LED on the front panel of the system case will be lit. The LED on the monitor may be lit or switch between orange and green colors after the system is on. If it complies with green standards or if it has the power stand-by feature, the system will run the Power-on test. While the tests are running, the BIOS will alarm beeps or additional message will appear on the screen. 21 If you do not see anything within 30 seconds after you turn on the power. The system may have failed on power-on test. Recheck your jumper settings and connections or call the vender for assistance. 6. During the power-on test, press <Delete> key to enter BIOS setup. Power off your computer: You must exit or shut down your operating system before switch off the power. For ATX power supply, you can press ATX power switch after exiting or shutting down your operating system. If you use Windows 9X, click "Start", click "Shut down" and then click "Shut down the computer?". The power should be off after windows shuts down. [. . . ] Chapter 4 DRIVER & FREE PROGRAM INSTALLATION There is a MAGIC INSTALL CD disk in the package. This CD has all the drivers you need and some free application programs and utility programs. In addition, this CD also includes an auto-detect software which can tell you which hardware is installed and which driver is needed so that your system can function properly. We call this auto detect software MAGIC INSTALL. [. . . ]