User manual JOHN DEERE JX90

[. . . ] English When you are reading the operator's manual, please unfold the front and back page. Risk caused by thrown elements when the motor is running - Maintain the safety gap / Keep others away!Disconnect the spark plug connector before performing any maintenance work. Beware of hot surfaces - do not touch the engine and exhaust. [. . . ] However the oil level should not be above "FULL" mark. € After filling up for the first time remove the “NO OIL” sign on top of the engine. 9 Filling with fuel Safety instruction!See table for explanation of symbols page 3 – – – – – Only fill the tank with fresh and clean unleaded standard petrol. fuel with up to 10% ethanol is acceptable. The petrol tap should be kept closed Y2 !Fill tank with fuel using a funnel up to max. 9 STARTING THE ENGINE (Illustration S2 + C + E ) Only start the engine when standing behind of the mower. € When the engine is cold, push the actuation lever (1) into the position I/I" (Choke) (2) C . € Slowly pull the starter cable (4) until resistance is felt, then rapidly pull it out E , – the engine begins to run, slowly recoil the cable. € Under certain circumstances the starting process must be repeated. € As soon as the engine has started running, put the actuation lever (1) on position "Hot start/operation" (3) C . € Once the engine is warm, push the actuation lever to position "Hot start/operation" (3) and as described above, start the engine. € If the engine does not start running, then proceed as when starting a cold engine. € In the position "Hot start/operation" the engine runs at maximum power and maximum speed which is required for a clean cutting pattern (engine speed = blade speed). CAUTION Hold the starter cable handle firmly when starting. The handle may otherwise slip out of your hand. See table for explanation of symbols page 3 Only switch on the cutting deck when standing behind the mower. Place the mower on a level surface where the grass is not too high (high grass inhibits the start of the cutter bar and makes starting more difficult). Where this is not possible, position the mower in such a way that the cutter is facing diagonally away from the user, although only as far as absolutely necessary. € Press and hold down the safety control bracket (1) against the upper section of the handlebar. € Push the lever (2) quickly forward as far as the stop, and then release. [. . . ] Always keep the machine in a clean condition in a closed, dry room out of reach of children. Air filter dirty Engine performance decreases Engine runs irregularly Air filter dirty. Remedy Fill fuel tank with clean and fresh fuel. Press on spark plug connector or have it checked by an authorized dealer. [. . . ]