User manual JOHN LEWIS JLDWW1201

[. . . ] JLDWW 1201 Dishwasher Instruction manual Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. Installation q Your dishwasher in day-to-day use q This appliance is heavy. Check your dishwasher for any transport damage. [. . . ] To interrupt or cancel a washing programme in progress Interrupt or cancel a washing programme in progress ONLY if it's absolutely necessary. Hot steam may escape when the door is opened. Open the door carefully. To interrupt a washing programme in progress a) Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point at which it was interrupted. b) Press the On/Off button, in this case all the indicator lights turn off. Press the On/Off button again; the programme will start from the point at which it was interrupted. 5. Setting and starting the programme To select a programme, press the button of the programme you wish to select, the indicator light of the button illuminates and in the digital display will appear, flashing, the running time of the programme that has been set (in minutes). The Programme time indicator light illuminates. After about 3 seconds from the last pressure of a button the programme starts automatically. In the digital display the running time of the programme is no longer flashing, the Programme time indicator light remains illuminated. To cancel a washing programme in progress To cancel a washing programme you have to reset the dishwasher; press simultaneously the function buttons 2 and 3 for about 2 seconds, the indicator light of the running programme starts flashing for about 2 seconds. After about 2 seconds all the indicator lights will turn off (except for the On/Off indicator light and eventually the rinse aid and salt indicator lights) indicating that the running programme has been cancelled. If a new washing programme will be selected, check that there is detergent in the detergent dispenser. Setting and starting the programme with the delay start The setting of the delay start occurs before selecting the programme Press the delay start button until the flashing number of the hours for the delay start will appear in the digital display (from 1h to 19h). In the digital display will appear, for a moment, the running time of the programme and then again appears the selected delay start time. As soon as the number of hours is displayed without flashing, the countdown for the delay start is active. The countdown will decrease with steps of 1 hour. The opening of the door during the countdown will not modify the delay start. Once the delay start has elapsed the programme will start automatically. Note: With the delay start set, the Programme time indicator light turns off. Once the countdown of the delay start has elapsed, the washing programme will start automatically and the Programme time indicator light will illuminate. Note: it is possible to select a washing programme and the delay start also with the door slightly opened. In this case the start of the programme or of the countdown for the delay start will start automatically after the closure of the door. Until this moment it is possible to change or modify the setting made. 7. [. . . ] The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water. The sink plug must not be in place when the machine is draining as this could cause the water to syphon back into the machine. If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided. CS18 Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. Attention! Our appliances are supplied with a security device to protect against the return of dirty water back into the machine. [. . . ]